Precision Power D500/1, D2000/1 manual Opposite Channel, Same Channel, Precision PowerTM Dealer or

Page 22

OPPOSITE CHANNEL

NO SOUND Is the LED illuminated?

YES

NO

Check Power and Remote turn-on wire for voltage. Make sure the ground wire is secure.

STILL NO SOUND

See your Authorized Precision PowerTM Dealer or call 1-800-62POWER.

SOUND IN ONE CHANNEL ONLY

Reverse the left and right speakers by unplugging the speaker connector, turning it over and plugging it back in.

SOUND IS NOW IN
OPPOSITE CHANNEL				SAME CHANNEL
Reverse RCA inputs.				Problem is in the speaker or
				speaker wire of the silent
				channel.
		SOUND IS NOW IN
		SOUND IS NOW IN
OPPOSITE CHANNEL				SAME CHANNEL
Reverse RCA inputs				Problem is in the amplifier.
at head unit.				See your local Authorized
				Precision PowerTM Dealer or
				call 1-800-62POWER.
			SOUND IS NOW IN
			SOUND IS NOW IN
OPPOSITE CHANNEL				SAME CHANNEL
Problem is in the head				Problem is in the RCA
unit or before the amplifier.				cables.

21

Image 22

Contents D1000/1 AMPLIFIER MODELSD500/1 D2000/1TABLE OF CONTENTS SERVICE CONGRATULATIONSCEA SPECIFICATIONS FEATURESWHAT’S INCLUDED General Specifications SPECIFICATIONSNominal Power Ratings D500/1Fuse The LEDs provide the following indications Small flat blade screwdriver When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inchof insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure youve maintained proper polarity before securing each wire POWERLOCKTM Total RMS output X 1.3 = Total Input Wattage 1300W= 108 Amps total current draw 12V 3mm hex Power wiresPOWERLOCK CONNECTORS wrenchFRONT PLATE DIAGRAMS XOVER12 D500/1, D1000/1 END PLATE DIAGRAMSD2000/1, D3000/1 ADVANCED INSTRUMENTATION INPUT INPUTSSOURCE Headunit Optional QBASS REMOTETM QBASS PLUSTMQBASS PLUS SPECIFICATIONS QBASSTM Settings D500/1, D1000/1, D2000/1, and D3000/1 TC-XCROSSOVERCROSSOVER DETENT CHART HIGH MASS INTERNAL HEATSINK ADJUSTING INPUT GAINTROUBLESHOOTING AP-IVPROTECTION CIRCUITSAME CHANNEL Precision PowerTM Dealer orOPPOSITE CHANNEL OPPOSITE CHANNELLIMITED TWO YEAR CONSUMER WARRANTY