Precision Power D3000/1, D2000/1, D500/1, D1000/1 manual

Page 9

When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inch of insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure you've maintained proper polarity before securing each wire.

Note: The cables running from the battery to the rear of the car should be installed on the side of the car opposite to the antenna.

When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inch of insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure you've maintained proper polarity before securing each wire.

8

Image 9

Contents D500/1 AMPLIFIER MODELSD1000/1 D2000/1TABLE OF CONTENTS CONGRATULATIONS SERVICEFEATURES CEA SPECIFICATIONSWHAT’S INCLUDED Nominal Power Ratings SPECIFICATIONSGeneral Specifications D500/1Fuse The LEDs provide the following indications Small flat blade screwdriver When using 16 gauge wire or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn on wires. Cut off excess and, using wire strippers, strip 1/4-inchof insulation. Locate the speaker/remote turn- on PowerLockTM connector. Using a hex wrench loosen the screws on the upperside of the connector. Insert the speaker leads into the end and secure with the hex wrench. Check to be sure youve maintained proper polarity before securing each wire POWERLOCKTM Total RMS output X 1.3 = Total Input Wattage 1300W= 108 Amps total current draw 12V POWERLOCK CONNECTORS Power wires3mm hex wrenchXOVER FRONT PLATE DIAGRAMSEND PLATE DIAGRAMS 12 D500/1, D1000/1D2000/1, D3000/1 INPUTS ADVANCED INSTRUMENTATION INPUTSOURCE Headunit QBASS PLUSTM Optional QBASS REMOTETMQBASS PLUS SPECIFICATIONS QBASSTM Settings TC-XCROSSOVER D500/1, D1000/1, D2000/1, and D3000/1CROSSOVER DETENT CHART TROUBLESHOOTING ADJUSTING INPUT GAINHIGH MASS INTERNAL HEATSINK AP-IVPROTECTION CIRCUITOPPOSITE CHANNEL Precision PowerTM Dealer orSAME CHANNEL OPPOSITE CHANNELLIMITED TWO YEAR CONSUMER WARRANTY