Kenmore 9743678, 9743680, 9743679 Electrical, We recommend Time-delay fuse or circuit breaker

Page 6

continuedfrompage4

Electrical

It is the customer'sresponsibility:

To contact a qualified electrician. To assure that the electrical

installation is adequate and in conformance with all national and local codes and ordinances.

You must have:

I/120-volt,60-Hz, AC-only, 15- or 20-amp., fused electrical supply.

i/COPPER WIRE ONLY.

We recommend:

v' a time-delay fuse or circuit breaker.

a separate circuit.

iv'use flexible, armored or non-metallic sheathed, copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances.

use strain relief method provided with house wiring junction box or install a U.L.-listed/CSA-oertified clamp connector to the house wiring junction box. If using conduit, use a U.L-listed/CSA-certified conduit connector.

v' use Power Supply Cord Kit (Part No. 4317824) available from your Sears store or service center. Follow the kit instructions for installing the power supply cord.

If kit is unavailable, use a U.L.-listed, 16-gauge, three-conductor power

supply cord that meets all local codes and ordinances. Maximum

length of the power supply cord is 6 feet (1.8m).

a clamp connector to fit a 7/8" (2.2cm) diameter hole is required to

Image 6
Contents Undercounter Dishwasher Doing so willPage Parts supplied Cabinet opening Helpful TIP We recommend Time-delay fuse or circuit breaker ElectricalWater Drain4K2461cm Disconnect the power supply. Turn water off ElectricalFrompage8 Metal cabinet Cover hole withWater line Drain hose 11c 11d Put dtshwasher corner posts 0 behind If you are installing a power supply Frompage14 Remove cardboard from under dishwasher Electrical Connection Tightenclampconnectororconduit connectorscrews Water Connection Compressiom. sDrain Connection Water supply and checkfor leaksDII If dishwasher does not operate If you have installation questions To customizeyourdishwasher