1
backfront
parletrasem pmledelantera
arri_re avant
1
upen ano ClOSe[fie ooor several [lllle_. The door should open and close easily.
If the door closes too quickly, decrease the spring _ tension by moving the
spring end _ toward the front of the dishwasher.If the door falls open, increase the spring tension by moving the spring end toward the back of the dishwasher. Springs should be in the same notches on left and right sides.
Read the Owner'sManual that came with your dishwasher.
Check that all parts have been installed and no steps were skipped. Check that you have all the tools you used.
At fuse box or circuit breaker, turn on
electrical power supply to dishwasher. Start dishwasher and allow it to
complete the "Water Miser" cycle. Check that dishwasher is working
properly and that there are no water I_k_
Check that grounding clip O is attached to the access panel. Put lower panel in
place and start screws through lower pane holes and into dishwasher frame. Do not
tighten. Slide access panel over and down onto screws. Reinstall screws through
holes in top of access panel. Check that bottom edge of lower panel contacts the floor. Tighten lower access panel screws.
If dishwasher does not operate:
Has the circuit breaker tripped or the house fuse blown?
Is the door closed tightly and latched?
v' Has the cycle been set correctly to
start the dishwasher?22 _'Is the water turned on?