Oven Controls
As soon as Self Clean becomes active, a motor driven lock mechanism will begin locking the oven door automatically and door Loc will appear in the display (Figure 19). Do not open the oven door when door Loc is displayed (allow 15 seconds for the lock mechanism to lock the oven).
Once the oven door has locked, CLn will appear in the display indicating Self Clean has started.
Figure 19: Door locking (L) and active Clean (R) shown
Figure 20: Hot oven door locked (L) door open message (R).
When Self Clean is finished:
Use caution when opening the oven door after self cleaning. The oven may still be very hot and can cause burns. To avoid possible burns stand to the side of the oven when opening the oven door to allow hot air or steam to escape.
1.Cln message will turn off and Hot will appear in display window (Figure 20).
2.Once the oven has cooled down (about 1 hour) and Hot is no longer displayed, the door Opn message will appear. When this message turns off the oven door may be opened.
3.When the oven interior has completely cooled, wipe away any residue or powdered ash with a damp cloth or paper towel.
Important note:
The kitchen area should be well ventilated. Use an open window, ventilation fan or exhaust hood during the first self clean cycle to help eliminate the normal odors associated with the 1st self clean cycle.
When the clean time finishes the oven door will remain locked until the oven has cooled sufficiently. In addition to the clean time that was programmed, allow about 1 additional hour for the oven to cool before opening the oven door. The Self Clean function will not operate when the oven lockout is active.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3 hours and a start time of 9:00 o’clock:
1.Be sure the clock is set with the correct time of day, the oven is empty and ALL oven racks are removed. Be sure oven door is completely closed.
2.Press Delay Start.
3.Using numeric keypad enter 9 0 0 for time to start.
4.Press 
to accept
5.Press Self Clean.
6.Press 
.
If it becomes necessary to stop Self Clean when active:
1.Press 
.
2.If Self Clean has heated the oven to a high temperature, allow enough time for the oven to cool and the door Opn message to appear (Figure 20). When this message turns off the oven may be opened.
3.Before restarting Self Clean, be sure to read important notes below.
Important note:
•When Self Clean is active you may check the amount of clean time remaining by pressing the Self Clean key once.
•If your clock is set with the (default) 12 hr display mode, the Delay Start for a Self Clean can only be programmed to start up to 11 hours and 59 minutes after the time showing in the display (be sure to set the clock to current time before programming a delay start). To set a Delay Start Self Clean to begin 12 or more hours (maximum is 23 hours and 59 minutes) after the time of setting, be sure to first set the control in the 24 Hr display mode.
•If Self Clean was active and then interrupted by a power failure or cancelled before the oven was thoroughly cleaned, it may be necessary to run another Self Clean cycle.
•If the oven temperature was high enough when Self Clean was interrupted the oven control may not allow another Self Clean cycle to be set for up to 4 hours.
20