Setting The Clock
When the appliance is first powered up, 12:00 will flash in the display (Figure 3). The time of day must first be set before operating the oven.
Figure 3: 12:00 in display before setting clock
To set clock to 1:30:
1.Press 
.
2.Enter 1 3 0 using numeric keypad.
3.Press 
.
Important note:
The clock cannot be changed when a Cook Time, Self Clean, Delay Start or cooking feature is active.
Setting Timer
The minute timer allows you to track your cooking times without interfering with the cooking process. The timer may be set from a minimum time of 1 minute to a maximum of 11 hours and 59 minutes.
To set timer for 5 minutes:
1.Press Timer Set-Off.
2.Enter 5 using numeric keypad.
3. Press 
to start timer. When set time ends, END will show in the display and the control will sound a beep three times every 30 seconds until Timer
To cancel the timer when active press Timer
Important note:
•The timer does not start or stop the cooking process. It serves as an extra minute timer that will beep when the set time has run out. The timer may be used alone or while using any of the other oven functions.
•When timer is set for more than 1 hour it will display hours and minutes until 1 hour remains. When less than 1 hour remains, the display counts down in minutes and seconds. With less than 1 minute remaining, only seconds will display.
•If the timer is active during a cooking process, the timer will show in the display. To view the status of any other active oven function, press the key of the cooking function once and it will appear in the display for a few seconds.
Oven Controls
Add 1 Minute
Use Add 1 Minute to set additional minutes to the timer. Each press of the key will add 1 minute. If Add 1 Minute is pressed when the timer is not active, the timer will activate and begin counting down from 1 minute.
To add 2 minutes to the timer:
Press Add 1 Minute twice.
Setting 12 hour or 24 hour display mode
The clock display mode allows you to select 12 hr or 24 hr modes. The factory
To set 12 hr or 24 hr display mode:
1.Press and hold 
for 6 seconds.
2.Press Self Clean to toggle between 12 Hr day or 24 Hr day display modes. (Figure 4)
3.Press 
to accept choice.
Figure 4: 12 Hr dAy and 24 Hr dAy settings
Changing Between Continuous Bake Setting or 12 Hour Energy Saving
The oven control has a factory preset
To change between continuous bake or 12 Hour Energy Saving feature:
1.Press and hold Timer
2.Press Self Clean to toggle between 12 Hour OFF or Stay On (Figure 5) feature.
3.Press 
to accept choice
Figure 5: 12 hr energy saving (L) and continuous setting (R)
9