Kenmore 790. 4789 manual Setting Continuous Bake or 12 Hour Energy Saving, Display, Instructions

Setting the Clock

Setting Continuous Bake or 12 Hour Energy Saving

The TIMER _ and FLEX CLEAN _ pads control the Continuous Bake or 12 Hour Energy Saving features. The oven

control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left on for

more than t t hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking.

To	set the	control	for Continuous Bake or 12 Hour	Energy Savingfeatures
		iNSTRUCTiONS			PRESS	DISPLAY
t.	Press and hold _olf_		for 7 seconds (Figure1). After 7 seconds	"12h" or	(_s_ for 7
	"- -h" will appear in the display and the control will beep once.				seconds
2.	Press _	to switch between the 12 Hour Energy Saving and			@	Figure	1
	continuous bake features. Note: "12h" (Figure 2) in the display indicates
	the control is set for the 12 Hour Energy Saving mode and "- -h" indicates
	the control is set for the Continuous Bake feature (Figure 3).
	Press	to accept the change (Figure 4; display will return to time				Figure	2
3.	of day) or press (_		to reject the change.
						Figure	3
Setting Kitchen Timer
The TIMER		pad controls the Kitchen Timer feature. The Kitchen Timer			serves as an extra timer	in theFiqurekitchen4 that will

beep when the set time has run out. It does not start or stop cooking. The Kitchen Timer feature can be used during any of the other oven control functions. Refer to "Minimum and Maximum Control Pad Settings" for time amount settings.

				INSTRUCTIONS			PRESS
To set the Kitchen Timer (example for 5 minutes)
1.	Press	_.	.....-- --	will appear and "TIMER" will flash in the		display		_
	(Figure 5).
2.	Press	the number		pads to set the desired	time in the display	(example
		). Press	START: The time will begin		to count down with "5:00"		(_	i START

and "TIMER" will stay in the display (Figure 6). Note: if _ STARTiS not

pressed the timer will return to the time of day after 25 seconds.

3.When the set time has run out, "End" and "TIMER" will show in the display (Figure 7). The clock will sound with 3 beeps every 5 seconds

until	_	is pressed.
To cancel the Kitchen Timer before the set time has run out
Press _.		The display	will return	to the time of day.
To Set	Add	1 Minute	Feature	@

DISPLAY

Figure 5

Figure 6

Figure 7

The _ ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the _ pad is pressed, 1 minute is

added to the Minute Timer feature if this feature is already active. If the Minute Timer feature is not active and the

pad is pressed, the Minute Timer feature will become active and will begin counting down from 1 minute. For further information on how to set the Minute Timer feature see To Set the Minute Timer instructions above.

10