Kenmore 790.4107 manual Removing and Replacing the Oven Door, To Replace Oven Door

Care & Cleaning

Removing and Replacing the Oven Door

The oven door is heavy. Be careful when removing and lifting the door. Do not lift the oven door by the handle.

Most oven doors contain glass that can

break. Read the following recommendations:

°Do not close the oven door until all the interior oven racks are fully inserted and retracted to the back of the oven.

°Do not hit the glass with pots, pans, or any other object. The oven door glass may break or even break at a later time unexpectedly.

°Scratching, hitting, jarring or stressing the oven door glass may weaken its structure causing an increased risk of breakage at a later time.

°You may use a glass cleaner on the outside of the oven door glass. Do not spray or allow water or the cleaner to enter or drip down into the oven door vents. Spray cleaner on cloth first and then wipe the oven door clean.

°Do not use strong oven cleaners, powders or any harsh abrasive cleaning materials on the outside of the oven door or glass.

°Never clean the oven door gasket. The oven door gasket should always clean during the Self-clean cycle.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor - See Figure 1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Figure 2). A tool such as a small fiat= blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 4).

To Replace Oven Door:

1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm onto the roller pins located on each side of the oven door frame (See Fig. 4). Also, seat the notch of the hinge arm onto the bottom of the slot at the same time you seat the hook. The hook and notch of the hinge arms must be fully seated onto the roller pins and bottom of the slot.

3.Fully open the oven door (horizontal with floor - See Figure 1).

4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Figure 2) to the locked position.

5.Close the oven door.

Door Hinge locations

with oven door fully open

Figure

Figure 2

Oven door

Figure 3

Roller pin

Hinge arm hook

Hinge arm notch

Slot bottom