Adjusting angle of tool base
Loosen the wing bolts and adjust the angle of the tool base (5' per graduation) to
-
Gradual__
~Wing b o l t
obtain the desired cutting angle.
Wing n u t
Base
It of
ring
Adjusting amount of chamfering
To adjust the amount of chamfering, loosen the wing nuts and adjust the trimmer shoe.
CAUTION :
With the tool unplugged and switch in the "OFF" position, rotate the collet nut on the tool several times to be sure that the bit turns freely and does not contact the tool base or trimmer shoe in any way.
Switch action
To start the tool, move the switch lever to the "ON" position. To stop, move the switch lever to the "OFF" position.
Operation
Turn the tool on without the bit making any contact with the workpiece and wait until the bit attains full speed. Then move the tool over the workpiece surface, keep- ing the tool base and trimmer shoe flush with the sides of the workpiece.
6