Craftsman 917.259592 owner manual Other, Battery, Fuel System, Engine OIL, Cylinders

Page 28

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor wilf not be used for 30 days or more,

--

i

I _

CAUTION: Never store the tractor with

!,_ _, gasoline in the tank inside a building

,_where fumes may reach an open flame

_

or spark.

Allow the engine to cool

_eforestoring!

TRACTOR

Remove mower from tractor for winter storage.. When mower is to be stored for a period of time, clean it thor- oughly, remove all dirt, grease, leaves, etc.. Store in a clean, dry area.

oClean entire tractor (See"CLEANING" in the Customer Responsibilities section of this manual).

Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

Lubricate as shown in the Customer Responsibilities section of this manual..

oBe sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

o Fully charge the battery for storage.

oAfter a period of time in storage, battery may require recharging.

-To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in the Cus- tomer Responsibilities section of this manual)

°After cleaning, leave cables disconnected and place

cables where they cannot come in contact with battery terminals.

oBe sure battery drain tube is securely attached.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.'

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER,

FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED

FUELS (CALLED GASOHOL OR USING ETHANOL OR

METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING

STORAGE ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE,

oDrain the fuel tank°

=Start the engine and let it run until the fuel lines and carburetor are empty,

.

Never use engine or carburetor cleaner products in the

 

fuel tank or permanent damage may occur,,

,Use fresh fuel next season

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age.. Add stabilizer to gasoline in fuet tank or storage container. Always follow the mix ratio found on stabilizer

container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do

not drain the gas tank and carburetor if using fuel stabitizer_

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Customer Responsibilities section of this manual).

CYLINDERS

o Remove spark plug(s).

oPour one ounce of oil through spark plug hole(s) into cytinder(s)o

oTurn ignition key to"START" position for a few seconds to distribute oil

Replace with new spark plug(s)

OTHER

. Do not store gasoline from one season to another,

°Replace your gasoline can if your can starts to rust, Rust and/or dirt in your gasoline will cause problems,

If possible, store your tractor indoors and cover it to give protection from dust and dirt,

. Cover your tractor with a suitable protective cover that does not retain moisture° Do not use plastic, Plastic cannot breathe which allows condensation to form and

witl cause your tractor to rust,

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM

28

Image 28
Contents RR r+Zli4IIii + Safe OperationSAFETYPractices RULESfor Ride-On Mowers Model Product SpecificationsSerial Number Date of Purchase Table of Contents Attachments Engine MaintenancePerformance Contents of Hardware Pack Assembly Tools Required for AssemblyBefore Rolling Tractor OFF Skid Unpack CartonAssembly Connect Battery See FigAssemble Gauge Wheels to Mower Deck See FigInstall Mulcher Plate See Figs To Convert to Bagging or DischargingCheck Tire Pressure Check for Proper Position of ALL BeltsCheck Brake System Check Deck LevelnessOperation LockERATmON To Adjust Mower Cutting Height HOW to USE Your TractorSee Fig Operation To Operate Mower See FigTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission StartingMowing TiPS Mulching Mowing TipsLubrication Chart Maintenance ScheduleCustomer General RecommendationsBattery TractorBlade Care Blade Removal See FigClean AIR Screen See Fig Transaxle CoolingEngine LubricationCleaning Custo ResponsibilitiesEngine OIL Filter See Fig MufflerTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing Both Front Links Must be Equal in LengthService AdjustmentsTo Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigServnce AN Adjustments To Adjust Motion Control LeverTransmission REMOVAL/REPLACEMENT To Replace Motion Drive BeltService AN Adjustments To Adjust Steering Wheel AlignmentFront Wheel TOE-INICAMBER To Remove Wheel for Repairs See FigTo Start Engine with a Weak Battery To Remove Hood and Grill AssemblyTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Carburetor See FigImportant Damage to the Needles Turned in TOO TightBattery OtherFuel System Engine OILProblem TroubleshootingPoints Problem Cause TroubleshootingCorrection Schematic 111Repair Parts ElectricalKEY Part DescriptionChassis and Enclosures KEY Drive KEY Part Description KEY Part NO. noUNC Steering Assembly REPAmR PartsSteering Assembly KEY Part NO, noDescription Seat AssemblyPart Description Decals Wheels & TiresKEY PartEngine Optional Equipment Spark ArresterNO, no EngineDescripon Mower Lift Tractor - Model Number161718 2O \ NO. no Mower Deck TUV Part DescriptionSqnk Hydro Gear Transaxle Model Number Cradle Kohler Engine Model Number CV15S, Type Number PS-41565 ExhaustAIR Intake KEY Part Description Blower Housing and Baffles Engine Controls KEY Part NO. noExhaust KEY Part @---1 Cylinder HEAD, Valve and BreatherKohler Engine Model Number CVt5S, Type Number PS-41565 Fuel SystemPart KEY Part Description NO. noKohler Engine Model Number CV15S, Type Number PS-41565 Ignition Electrical OIL PAN LubricationIgnition Electrical KEY Part Description OIL PAN/LUBRICATIONCrankcase KEY Part Starting System KEY PartRvice Otes Page SE CE Notes Suggested Guide for SiGHTiNG Slopes for Safe Operatron For Repair SERVICE, Call this Toll Free Number Owners UALI1IIl Lll Illlll Part Number