i | , i iii | i, | i,, | , | iii ¸ | ii | iii | ,i | ,i | , |
ASSEMBLY
HOW TO SET UP YOUR TRACTOR
CONNECT BATTERY (See Fig. 2)
nals by allowing a wrench or any other
objectCAUTION:to contactDo notbothshortterminalsbattery termiat the- same time. Before connecting battery,
remove metal bracelets, wristwatch bands, rings, etc°
Positive terminal must be connected
first to prevent sparking from acciden- tal grounding.
-Lift hood to raised position_
oOpen terminal access doors, remove terminal protec- tive caps and discard.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
oFirst connect RED battery cable to positive (+) batter,/ terminal with hex bolt, flat washer, lock washer a'ndhex nut as shown, Tighten securely_
INSTALL SEAT (See Fig, 3)
Adjust seat before tightening adjustment knob
. Remove cardboard packing on seat pan.
. Place seat on seat pan and assemble shoulder bolt, Tighten shoulder bolt securely.
•Assemble adjustment knob and flat washer Ioosely_ Do not tighten
•Lower seat into operating position and sit on seat.
•Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
. Get off seat without moving its adjusted position.
-Raise seat and tighten adjustment knob securely,.
SHOULDER | \ | _, \_'_ | _ ' _\ \ |
oConnect BLACK grounding cable to negative
tery terminal with remaining hex bolt, flat washer, lock washer and hex nut, Tighten securely,,
•Close terminal access doors. Use terminal access doors for:
oInspection for secure connections (to tighten hard- ware)_
. Inspection for corrosion.
. Testing battery_
o Jumping (if required).
oPeriodic charging.
|
| LOCK | FLAT |
HEX NUT | WASHER | WASHER | |
DISCARD TERMINAL | _ |
| HEX |
PROTECTIVE CAPS | X |
| BOLT |
TERMINAL |
| |
ACCESS |
|
|
DOOR | ", | POSITIVE |
| ¢ | (RED) |
| ._ | CABLE |
NEGATIVE
(BLACK}
CABLE
BO LT l_" _ __
KNOB
FIG. 3
ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 4)
The gauge wheels are desigr_ed to keep the mower deck in proper position when operating mowei" Be sure they are properly adjusted to ensure optimum mower performance.
•Assemble gauge wheels with tractor on a flat level surface.
•Adjust mower to desired cutting height (See 'q'OAD- JUST MOWER CUTTING HEIGHT" in the Operation section of this manual),,
. With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Instal[ gauge wheel in appropriate hole with shouider bolt, 3/8 washer, and
. Repeat for opposite side installing gauge wheel in same adjustment hole.
FIG. 2