Purgetransmission

-NOTE: Before starling, read the warm and cold sta_ng procedures below.

6.Insert key into ignition and turn key clockwise to "START" position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50 ° F and above)

7.When engine starts, slowly push choke control in until the engine

begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control

in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50 ° F and below)

7.When engine starts, slowly push choke control in until the engine

begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the

temperature.

NOTE: in extreme cold conditions, if engine will not start you may need to disengage the motion drive belt as follows:

1.Be sure parking brake is engaged.

2.Remove retainer spring from the drive belt tension handle to relieve belt tension.

3.Start engine and allow it to warm up for three (3) minutes.

4.Shut-off engine and engage parking brake.

5.Engage drive belt tension handle and replace the retainer spring.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather,

the transmission should be warmed up as follows:

1.Be sure the tractor is on level ground.

2.Place the motion control lever in neutral. Release the parking brake and let the brake slowly return to operating position.

3.Allow one minute for transmission to warm up. This can be done during the

engine warm up period.

•The attachments can be used during the engine warm-up period after the transmission has been warmed up and may require the choke control be

pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to

be adjusted for best engine performance. See "TO ADJUST CARBURETOR" in the

Service and Adjustments section of this manual.

,_CAUTION: Never engage or disen- gage freewheel lever while the engine is

running.

To ensure proper operation and perfor- mance, it is recommended that the

transmission be purged before operating tractor for the first time. This procedure will

remove any trapped air inside the trans- mission which may have developed dudng

shipping of your tractor.

IMPORTANT: Should your transmission require removal for service or replacement, it should be purged after reinstallation before operating the tractor.

1.Place tractor safely on level surface with engine off and parking brake set.

2.Disengage transmission by placing freewheel control in freewheeling position (See =TO TRANSPORT" in this section of manual).

3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. Disengage parking brake.

4.Move motion control lever to full

forward position and hold for five (5) seconds. Move lever to full reverse

position and hold for five (5) seconds. Repeat this procedure three (3) times.

NOTE" Dudng this procedure there will be no movement of drive wheels. The air is

being removed from hydraulic ddve system.