Craftsman 917.275021 manual Howto SET Upyourtractor Check Battery, Install Seat

	___.-_	Wheel Insert
_	J_'_--SteefingHex Bolt
	o-----Lock	Washer
Steedn"	_	Large Flat
		w s
Steering _	,
Sleeve	_::===_Ta	bs
Extension	I

Steering Shaft

Steerin!

Sleeve

HOWTO SET UPYOURTRACTOR CHECK BATTERY

1.Lift hood to raised position_ NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

INSTALL SEAT

Adjust seat before tightening adjustment knob.

1.Remove adjustment knob and fiat washer securing seat to cardboard packing and set aside for assembly of

erseat to tractor.

2. Pivot seat upward and remove from the cardboard packing. Remove the

cardboard packing and discard.

3. Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

4. Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

5. Pivot seat and pan forward and

assemble adjustment knob and flat washer loosely• Do not tighten.

6. Lower seat into operating position and sit in seat.

7. Slide seat until a comfortable position is reached which allows you to press

clutch/brake pedal all the way down.

8. Get off seat without moving its adjusted position.

9. Raise seat and tighten adjustment knob securely.

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor

from the skid.

Seat

	""	""	'	Label
•	--./		•

Shoulder

Bolt

J

Flat Washer

Adjustment Knob

9