•Keep battery and terminals clean.
-• Keep battery bolts tight.
•Keep small vent holes open.
•Recharge at
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.
1.Remove terminal guard.
2.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.
3.Rinse the battery with plain water and dry.
4.Clean terminals and battery cable ends with wire brush until bright.
5.Coat terminals with grease or petro- leum jelly.
6.Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND
ADJUSTMENTS section of this manual).
V-BELTS
Check
if necessary. The belts are not adjustable. Replace belts if they begin to slip from wea r.
TRANSAXLE COOLING
The transmission fan and cooling fins should be kept clean to assure proper cooling.
Do not attempt to clean fan or transmis- sion while engine is running or while the transmission is hot. To prevent possible damage to seals, do not use high pressure water or steam to clean transaxle.
•Inspect cooling fan to be sure fan blades are intact and clean.
•Inspect cooling fins for dirt, grass clippings and other materials. To
prevent damage to seals, do not use compressed air or high pressure sprayer to clean cooling fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory
and fluid maintenance is not required for the life of the transaxle. Should the
transaxle ever leak or require servicing, contact a Sears or other qualified service center.
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service classification
Select the oil'sSAE viscosity grade according to your expected operating temperature,
SAE VISCOSITY GRADES
|
|
|
| |
"C .36- | 0" | 10" | 20- | 30. |
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one
year.
Check the crankcase oil level before starting the engine and after each eight
(8)hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected before oil change. All oil must meet API service classification
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oil in a suitable container.
1.Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine when changing oil.
2.Remove cap from end of drain valve and install the drain tube onto the fitting.
3.Unlock drain valve by pushing upward slightly and turning counterclockwise.
4.To open, pull down on the drain valve.
5.After oil has drained completely, close
and lock the drain valve by pushing upward and turning clockwise until the pin is in the locked position as shown.
6.Remove the drain tube and replace the cap onto to the end of the drain valve.
7.Refill engine with oil through oil fill dipstick tube. Pour slowly, Do not
overfill. For approximate capacity see
=PRODUCT SPECIFICATIONS" section of this manual.
8.Use gauge on oil fill cap/dipstick for checking level, Insert dipstick into the
tube and rest the oil fill cap on the tube, Do not thread the cap onto the
tube when taking reading. Keep oil at =FULL" line on dipstick. Tighten cap onto the tube securely when finished.
22