Craftsman 917.275021 manual Move throttle control lever from slow to

NOTE: The high idle is set at the factory and cannot be adjusted.

2.Idle seeed settina - With throttle

control lever in slow position, engine should idle at 1200 RPM. If engine idles too slow or fast, turn idle speed

adjusting screw in or out until correct idle is attained.

3.Idle fuel needle settina - With throttle

control lever in slow position, turn idle fuel adjusting needle in (clockwise) until engine speed decreases and then turn out (counterclockwise) approximately 3/4 turn to obtain the best low speed performance.

4.Recheck idle speed. Readjust if necessary.

ACCELERATION TEST -

5.Move throttle control lever from slow to

fast position. If engine hesitates or dies, tum idle fuel adjusting needle

out (counterclockwise) 1/8 turn. Repeat test and continue to adjust, if necessary, until engine accelerates smoothly.

High speed stop is factory adjusted. Do not adjust-damage may result. IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the engine-governed high speed needs adjusting, contact a Sears or other qualified service center, which has proper equip-

ment and experience to make any necessary adjustments.

31