FRONTWHEELCAMBER
•Thefront wheel camber is not adjustable
on your tractor. If damage has occurred to affect the front wheel camber, contact contact a Sears or other qualified service center
A
Adjustment Sleeves
Jam Nuts
TO REMOVE WHEEL FOR REPAIRS
FRONTWHEEL-
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal.
3.Repair tire and reassemble.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
REAR WHEEL -
1.Block rear axle securely.
2.Remove five (5) hub bolts to allow wheel removal.
3.Repair tire and reassemble. Replace and tighten hub bolts securely.
NOTE: To seal tire punctures and prevent fiat tires due to slow leaks, tire sealant
may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
Washem
Retaining
Ring'
Axle
Cover
TO START ENGINE WITH A WEAK BATTERY
_hbcAIJTION:
If your battery is too weak to startthe engine, it
should be recharged. (See
If "jumper cables" are used for emergency starling, follow this procedure:
IMPORTANT: Your tractor is equipped with a 12 volt negative grounded system. The other vehical must also be a 12 volt negative grounded system. Do not use your tractor battery to start other vehicles.
TO
1.Connect each end of the RED cable to the POSITIVE (+) terminal of each
battery, taking care not to short against chassis.
2.Connect one end of the BLACK cable to the NEGATIVE
3.Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER-
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both battedes.
"Positive"=Negative"
(+)(-)
L.H. o
28