Craftsman YT 4500, 917.28990 To Check Brake, To Remove Wheel for Repairs, To Attach Jumper Cables

Page 27

4.Install belt on centerspan idler (E).

5.Install belt through stationary idler (C) and clutching idler (D).

6.Reinstall anti-rotation link (B) on right side of tractor. Tighten securely.

7.Reconnect clutch harness (A).

8.Make sure belt is in all pulley grooves and inside all belt guides and keepers.

9.Install mower (See "TO INSTALL MOWER" in this section of manual).

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a

level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Parktractoronalevet,dryconcreteorpaved surface, depress clutch/brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in "transmission dis-

engaged" position. Putt freewheel con- trol out and into the slot and release so

it is held in the disengaged position. The rear wheels must lock and skid when

you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or

other qualified service center.

FRONT WHEEL TOE=IN/CAMBER Your new tractor front wheel toe-in and cam-

ber is set at the factory and is normal. The front wheel toe-in and camber are not adjust-

able. If damage has occurred to affect the factory set front wheel toe-in or camber, con- tact a Sears or other qualified service center.

TO REMOVE WHEEL FOR REPAIRS

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).

3.Repair tire and reassemble.

Washers

Retaining

Ring

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

NOTE: To seat tire punctures and prevent

flat tires due to stow leaks, purchase and use tire sealant from Sears. Tire sealant

also prevents tire dry rot and corrosion.

TO START ENGINE WITH A WEAK BAT-

TERY

_,WARNING: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from batter- ies. Always wear eye protection when around batteries.

If your battery is too weak to start the en-

gine, it should be recharged. (See "BAT- TERY" in the MAINTENANCE section of

this manual).

If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1.Connect one end of the RED cable

to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable

to the NEGATIVE (-) terminal (C) of fully charged battery.

3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

Weak or Dead

Fully Charged

BatteryBattery

i

Axle Cover

\Square Key (Rear

Wheel Only)

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

TO REMOVE CABLES, REVERSE ORDER -

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Craftsman Craftsman Limited Warranty TWO Years on Tractor Days on BatterySears, Roebuck and Co,, Noffman Estates, IL General Operation IV. Towing Service Safe Handling of GasolineGeneralservice PRODUCTSPECIFiCATiONS Sears Installation ServiceFor prices and additional information call Keys MowerTo Remove Tractor from Carton Unpack Carton Tools Required for AssemblyCheck Battery Adjust SeatAttach Mower Side Suspen First Install ANTI-SWAY BAR S10Turnsteeringwheeltopositionwheels Straightforward Check for Proper Position of ALL Belts ChecklistCheck Tire Pressure Check Deck LevelnessCruisecontrol @@@@@Tractor Attachment Clutch SwitchService Reminder / Hour ME= Know Your TractorTo SET Parking Brake StoppingTo USE Throttle Control D To USE Cruise Control System CharacteristicsTo Adjust Mower Cutting Height To Adjust Gauge WheelsTowing Carts and Other Attachments Using the Reverse Operation SystemTo Operate on Hills To TransportTo Start Engine Before Starting the EngineADD Gasoline Mowing TiPS Purge TRANSMiSSiONBefore Each USE Maintenance ScheduleChart General RecommendationsOperator Presence System TiresTo Change Engine OIL To Service CartridgeTransaxle Pump Fluid BeltsClean AIR Screen MufflerIN=LINE Fuel Filter Deck Washout Port To Remove Mower To Level Mower To Install MowerVisual SIDE-TO-SIDE Adjustment Precision SIDE-TO-SIDE AdjustmentTo Replace Motion Drive Belt Mower Drive Belt InstallationBelt Installation To Replace Mower Drive Belt Mower Drive Belt RemovalTo Attach Jumper Cables To Check BrakeTo Remove Wheel for Repairs To Start Engine with a Weak BAT TerySembly Replacing BatteryOther Fuel SystemEngine OiL CylindersHard to ProblemCause Correction StartExcessive Loss of powerWhen Operator WillDischarge Poor cut unevenCutting Mower blades willROS OFFSuggested Guide for Sighting Slopes for Safe Operation DOS Anos Para Tractores Pendientes FuncionamientoIV. Remolque Servioio MANIPULACI6N Segura DE LA GasoljnaOperacjones DE Servicjo Generales @@@@@ Acuerdos DE PROTECCI!N Para Especircaciones DEL ProductoResponsabimdades DEL Cmente DvertenciaLa segadora LlavesPara Hacer Rodar EL Tractor Dad y la funci6n de los controlesMonte Rueda Delatentera DE LA Fije LOS Brazos DE Suspension LAT Jnstale LA Segadora Y LA CorreaDE Transmisjon Montaje DE LA SE,GADORA Y DE LA COR- REA DE TransmisionRealiceelmismoprocedimientoelotro ladodeltractor DA DE Todas LAS Correas REVISI6N DE LA Presion DE LAS LlantasRevision DE LA Nivelacion DEL Conjunto Revision DE LA Posicion ADECUA=Fuego ESTRANGU- R/PIDO LentoLacion Atras Hacia Adelante Crucero DE Embrague Accesorio DELPage Para Usar EL Control DE LA ACELER- ACI6N D Parada Cuchillas DE LA SegadoraIMPULSI6N DE Recorrido MotorPara Operar LA Segadora Para Ajustar LAS Ruedas CAUBRA- DorasCorte Para Ajustar LA Altura DE Corte DE LA SegadoraCronometro Para TransportarRemolque DE Carretillas O Otros Accesorios Para Operar EN CerrosAntes DE Hacer Arrancar Para Hacer Arrancar EL MotorArranque CON Tjempo Templado Arranque CON Tiempo FrioCalentamiento Para LA Transmision Automatica Rgar LA TransmisjonConsejos Para Segar Programade Mantenimiento Recomendaciones GeneralesAntes DE Cada USO Vfrifiiz Sistema Presencia Operador TractorOperaoion DEL Freno LlantasPara Cambiar EL Aceite DEL Motor MotorEnfriamiento DEL Transeje Nivel DEL Fluido DE LA Bomba DEL TransejeSilenciador Filtro DE Combustible EN LineaLimpieza Limpieza DE LA Entrada DE AIRE/AREAS DE EnfriamentoPuerto CubiertaLejos Instalar LA S,EGADORA Y LA Correa Servicio O DE Hacer AjustesPara Desmontar LA Cortadora CuidadoAjuste DE Delante a Atras Para Nivelar LA SegadoraRegulacion Visual DE Lado a Lado REGULACI6N DE LA PRECISI6N DE LadoMontaje DE LA Correa DE LA SEGA- Dora Para Cambiar LA Correa DE IMPUL=SI6N DE Movimiento Desmontaje DE LA CorreaPara Verificar SI Funciona Bien EL Freno Impresion / Inclinacion DE LAS RUE=Entreoierre Y Reles Para Adjuntar LOS Cables DE EmpalmeReemplazar LA Bateria Para Cambiar LA Bombilla DE LA LUZ DelanteraCarburador MotorAceite DEL Motor CilindrosOtros EL Motor Identificacion DE ProblemasProblema Causa Correccion Estrangulacion ChokeIDENTIFICACI6N DE Problemas ProblemacausaCorreccjon Rapido Iproblema Causa CorreccionGUJASUGERiDAPARAMEDIR LAS Pendientes CON LA Vista Para UNA Our Home Your Home

YT 4500, 917.28990 specifications

The Craftsman 917.28990 YT 4500 is a robust lawn tractor that combines power and performance with comfort and ease of use, making it an ideal choice for homeowners with medium to large yards. With its impressive features and innovative technologies, this machine stands out in the competitive landscape of lawn care equipment.

At the heart of the Craftsman YT 4500 is a powerful 24 HP Kohler engine. This engine delivers reliable performance, ensuring that the tractor can tackle a variety of tasks from mowing to hauling and even towing. With a 42-inch cutting deck, the YT 4500 effectively maneuvers through tight corners and delivers a clean, professional-looking cut on your lawn.

One of the standout features of the Craftsman YT 4500 is its hydrostatic transmission, which provides effortless control and smooth operation. This technology allows users to change speed and direction easily without the need for constant gear shifting, enhancing the user experience, especially over extended periods of use.

The tractor also boasts a comfortable high-back seat with adjustable features, providing ample support during long mowing sessions. The ergonomically designed steering wheel allows for easy maneuverability, making it suitable for users of all sizes.

To improve efficiency, the YT 4500 is equipped with a cutting height adjustment feature, allowing users to select from multiple cutting heights to accommodate various grass types and conditions. This flexibility ensures optimal results year-round.

Additionally, the Craftsman 917.28990 includes a mulching feature, which finely chops grass clippings and returns them to the lawn as natural fertilizer, promoting a healthier lawn while reducing the need for bagging clippings. For those requiring extra versatility, the tractor is compatible with various attachments, including snow plows, baggers, and more, enabling year-round tasks.

Overall, the Craftsman 917.28990 YT 4500 is an excellent investment for any homeowner seeking reliability, comfort, and versatility in a lawn tractor. Its combination of power, advanced technologies, and thoughtful design ensures that lawn care can be both efficient and enjoyable. Whether you are tackling a simple mow or an extensive landscaping project, the YT 4500 proves to be a valuable addition to your outdoor equipment lineup.
Top Page Image Contents