Craftsman 917.289281 manual Battery, Tires

Page 18

TRACTOR

Always observe safety rules when per- forming any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced. (See "TO CHECK BRAKE" in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See PSI on tires).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may

cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND

REVERSE OPERATION SYSTEM (ROS) Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as de- scribed, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disen-

gaged position.

CHECK OPERATOR PRESENCE

SYSTEM

•When the engine is running, any at- tempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any at- tempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never op- erate unless the operator is in the seat.

ROS "ON" Position Engine "ON" Position (Normal Operating)

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" posi- tion and the attachment clutch engaged, any attempt by the operator to drive in reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to drive in

reverse should NOT shut off the engine.

BLADE CARE

For best results mower blades must be

sharp. Replace worn, bent or damaged blades.

_I, CAUTION: Use only a replacement

blade approved by the manufacturer of your tractor. Using a blade not approved

by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL

1.Raise mower to highest position to al- low access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

2.Remove blade bolt by turning counter- clockwise.

3.Install new blade with stamped "GRASS SIDE" facing the ground.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

4.Install and tighten blade bolt securely

(45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

 

Blade

Blade Bolt

Assembly

(Special)

 

Center Hole

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. How-

ever, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents CRRFrSMR# SEARS, Roebuckand CO., Hoffman ESTATES, IL 60179 U.S.ACraftsman Limited Warranty Days on BatteryTWO Years on Tractor General Operation Service Safe Handling of GasolineGeneral Service Product Specifications Repair ProtectionFor prices and additional information call Keys Slope Sheet ToolsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper PositionH L I\1 Know Your Tractor Ignition Switch Used for starting and stopping the engineService REMINDER/HOUR Meter TractorEngine HOW to USE Your TractorStopping To Move ForwardTo Adjust Gauge Wheels System CharacteristicsTo Adjust Mower Cutting Height To Operate MowerTransmission Engaged Transmission Disengaged Using the Reverse Operation SystemTo Transport Reverse Operation System ROSCheck Engine OIL Level Service REMINDER/HOUR MeterTo Start Engine ADD GasolinePurge Transmission Automatic Transmission Warm UPMowing Tips Genera Purpose Grease @Refer to Maintenance Engine Section MaintenanceSchedule Battery TiresTransaxle Pump Fluid Engine LubricationMuffler Clean AIR ScreenAIR Filter Spark PlugsTo Install Mower To Remove Mower03042tex Precision SIDE-TO-SIDE Adjustment FRONT=TO=BACK AdjustmentVisual SIDE-TO-SIDE Adjustment To Level MowerBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltTo Remove Wheel for Repairs To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak BAT- TeryEngine To Replace FuseTo Clean Battery and Termi Fuel SystemEngine OIL Hard to start Engine will not turn over ProblemWill not start Cause CorrectionEngine Clicks but Problem CauseLoss Power Will not StartMower blades will not rotate Poor grass Poor cut = unevenCutting Discharge Headlights not working If so equippedDrive Battery Will notLoss Engine dies whenPage Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXDiAS Para BATERiAS GARANTiA Limitada DE CraftsmanDOS Anos Para Tractores Sears, Roebuck and Co., Hoffman Estates, ILFuncionamiento General III. Ninos IV. RemolqueSERVIClO Page Responsabilidades DEL Cliente Especificaciones DELProducto Acuerdos DE Proteccion Para LA ReparacionEL Montaje Hoja de pendiente Llaves Tubo de desagQeHerramientas Necesarias Para LA Caja DE Carton Desempaque LA Caja DE CartonRevision DEL Sistema DE Frenos La funcion de los controlesRevision DE LA Presion DE LAS Llantas FLISTA DE Revision@@@ Familiaricese CON SU Tractor Palanca DE Mando CRUCERO=Pedal DE Marchaadelante Se utiliza Como Usar SU Tractor MientoPara Operar LA Segadora Utilizar EL Mando CruceroPara Ajustar LA Altura DE Corte DE LA Segadora Para Parar LAS Cuchillas DE LA SegaTransmisi6n Eric anchada #ansmisi6n Desenganchada Agregue Gasolina MotorPara Hacer Arrancar EL Motor Arranque CON Tiempo Templado 50 Y M,SPurgar LA Transmision Consejos Para SegarAntes DE Cada USO Recomendaciones GeneralesPrograma DE Mantenimbento Tabla DE LUBRICACI6NTractor Transeje MotorLUBRICAClON LiMPIEZA Instale LA Segadora DE CespedPara Desmontar LA Cortadora Fije LOS Brazos DE Suspension03042tex Ajuste DE Delante a ATR,S Para Nivelar LA SegadoraRegulacion Visual DE Lado a Lado Regulacion DE LA Precision DE LadoInstalacion DE LA Correa Para Cambiar LA Correa DE Impulsion DE LA Cuchilla SegadoraRemocion DE LA Correa Montaje DE LA CorreaIMPRESI6N/ Inclinacion DE LAS RUE- DAS Delanteras Para Adjuntar LOS Cables DE EmpalmePara Cambiar LA Bombilla DE LA LUZ Delantera Otros Sistema DE CombustibleAceite DEL Motor Problema Causa Correccion Identificacion DE ProblemasContinuado Se portCausa Correccion Page Operacion Segura Solamente Ande Cuesta ARRiBA OCuesta Abajo Y no Atraviese EL Cerro Grados MAX Your Home Our Home

917.289281 specifications

The Craftsman 917.289281 is a robust lawn tractor designed for homeowners seeking efficiency and ease of use in maintaining their outdoor space. This model is particularly suitable for those with medium to large-sized lawns, offering a blend of strength, durability, and advanced technology that sets it apart in the competitive market of lawn equipment.

One of the standout features of the Craftsman 917.289281 is its powerful 19 horsepower Kohler engine. This reliable engine delivers reliable performance, ensuring that users can tackle tough mowing jobs without a hitch. Coupled with a smooth hydrostatic transmission, the mower provides seamless speed and direction control, allowing operators to maneuver easily around tight corners and obstacles.

The cutting deck of the Craftsman 917.289281 measures 42 inches, which strikes a balance between efficient mowing and maneuverability. The deck is constructed from high-quality materials, ensuring durability while effectively distributing grass clippings. Users can also take advantage of the adjustable cutting height, which ranges from 1.5 to 4 inches, providing versatility for varying grass lengths and types.

In terms of comfort, the Craftsman 917.289281 doesn't disappoint. It includes a plush, ergonomically designed seat allowing for longer periods of mowing without discomfort. The easy-to-reach controls, combined with a tight turning radius of 16 inches, make it simple for users to navigate around flower beds, trees, and other obstacles in their yard.

Another noteworthy aspect is its advanced technology. The mower is equipped with an automatic choke system, simplifying the starting process—no more fussing with manual chokes. Moreover, it features a built-in LED headlight system, ensuring visibility during early morning or late evening mowing sessions.

Additionally, maintaining the Craftsman 917.289281 is straightforward. The mower’s design allows for easy access to the engine and other components, making routine maintenance tasks hassle-free.

In conclusion, the Craftsman 917.289281 is a reliable, feature-rich lawn tractor tailored for homeowners who seek efficiency and comfort while maintaining their lawns. With its powerful engine, ease of use, and thoughtful design, it stands as a formidable ally in outdoor landscaping efforts. For anyone looking to invest in a lawn tractor, the Craftsman 917.289281 offers an impressive combination of performance and features.
Top Page Image Contents