6.Remove the drain tube and replace the cap onto the end of the drain valve.
7.Refill engine with oil through oil fill dip- stick tube. Pour slowly. Do not overfill.
For approximate capacity see "PROD-
UCT SPECIFICATIONS" section of this manual.
8.Use gauge on oil fill cap/dipstick for checking level. For accurate reading, insert dipstick into the tube and push down firmly into place before removing. Keep oil up to, but not over, the "FULl" line on dipstick. Push dipstick down
firmly into the tube when finished.
AIR FILTER
Your engine will not run properly using a dirty air filter. Service air cleaner more
often under dusty conditions. See Engine Manual.
ENGINE OiL FILTER
Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stub- born dried gum fibers.
CLEAN AIR INTAKE/COOLING AREAS To insure proper cooling, make sure the grass screen, cooling fins, and other exter-
nal surfaces of the engine are kept clean at all times.
Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled.
NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.
MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as it could cre- ate a fire hazard and/or damage.
SPARK PLUG(S)
Replace spark plug(s) at the beginning of each mowing season or after every 100 hours of operation, whichever occurs
first. Spark plug type and gap setting are
shown in "PRODUCT SPECIFICATIONS" section of this manual.
IN=LINE FUEL FILTER
The fue! filter should be replaced once each season. If fuel filter becomes
clogged, obstructing fuel flow to carbure-
tor, replacement is required.
1.With engine cool, remove filter and plug fuel line sections.
2.Place new fue! filter in position in fuel line with arrow pointing towards carbu- retor.
3.Be sure there are no fuel line leaks and clamps are properly positioned.
4.Immediately wipe up any spilled gaso- line.
Clamp
CLEANING
•Clean engine, battery, seat, finish, etc. of all foreign matter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and transmis- sion are covered to keep water out. Water
in engine or transmission will shorten the useful life of your tractor. Use compressed
air or a leaf blower to remove grass, leaves and trash from tractor and mower.
20