Craftsman 917.2738 owner manual 0round, To Level Mower Housing

Page 24

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure

tires are properly inflated (See "PROD- UCT SPECIFICATIONS" section of this

manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjust- ment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift

link adjustment nut on that side. NOTE: Each full turn of adjustment nut will change mower height about 1/8".

• Recheck measurements after adjusting.

 

 

Bottom edge of

Bottom edge

___

mower to ground

of mower to ___

4

/

0round...

L/

A_ T -_Ground

Line_ -Y _A

Arm

FRONT-TO-BACK ADJUSTMENT IMPORTANT: Deck must be level side-to side. If the following front-to-back adjust- ment is necessary, be sure to adjust both

front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower housing should be adjusted so

that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in

its highest position.

Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjust- ments, check that both front links are

equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut "E"

on both front links an equal number of turns.

•When distance "D" is 1/8" to 1/2"

lower at front than rear, tighten nuts "F" against trunnion on both front links.

•To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns.The two front links must remain equal in length.

•When distance "D" is 1/8" to 1/2" lower

at front than rear, tighten nut "F" against trunnion on both front links.

•Recheck side-to-side adjustment.

Both Front Links Should be Equal in Length

Jt "E"

Trunnion

Front Links

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Jcriiftsmiinj Limited Warranty on Craftsman Riding Equipment Limited Warranty on BatteryGeneral Operation II. Slope OperationIV. Service Do notIII. Children Across Product Specifications Sears Installation ServiceCustomer Responsibilities UIRSteering Wheel KeysHowto SET UP Your Tractor Tools Required for AssemblyCheck Battery To Remove Tractor fromInstall Seat AdjInstall Mulcher Plate Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake System@@@@@ Discharging of battery Attachment Clutch Lever Used Know Your TractorMotion Control Lever Selects HOW to USE Your Tractor To Adjust Mower Cutting HeightTo SET Parking Brake To USE Throttle ControlTo Adjust Gauge Wheels To Operate MowerTo Operate On Hills Do not drive up or downTransmission Engaged Transmission Disengaged Before Starting the EngineCheck Engine OIL Level ADD GasolineAutomatictransmissionwarmup Purge TransmissionMowing Tips Mulching Mowing TipsImportant For best performance, keep Lubrication Chart General RecommendationsAsyoucomplete Before Each USETractor Operator Presence SystemBlade Removal To Sharpen BladeTo Clean Battery and Terminals Transaxle Pump FluidBelts Engine LubricationClean AIR Screen Clean AIR INTAKE/COOLING AreasAIR Filter Engine OIL FilterCleaning MufflerSpark Plugs IN-LINE Fuel FilterTo Install Mower To Level Mower Housing 0roundTo Check and Adjust Brake To Replace Mower Blade Drive BeltTransmission Removal Replacement Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs Replacing Battery To Start Engine with a Weak BAT- TE RYTo Attach Jumper Cables Interlocks and RelaysEngine CarburetorBattery EngineFuel System Troubleshooting Chart ProblemLoss of power Will not start Hard to start Engine will not turn overExcessive VibrationEngine continues To run whenTroubleshooting Chart Problem Cause CorrectionTractor - Model Number Schematic Wiring Insulated ClipsTractor - Model Number ELECTRICAL22 Tractor - Model Number Electrical KEY Part DescriptionTractor - Model Number 917.273800 Chassis and Enclosures 206 Tractor - Model Number Ground Drive Link Transaxle Tractor - Model Number 917.273800 Steering Assembly Tractor - Model Number 917.273800 Steering Assembly Tractor - Model Number Tractor - Model Number Engine Tractor - Model Number Seat Assembly KEY Part Tractor - Model Number Decals Wheels &TIRESTractor - Model Number Lift Assembly 14//FF Tractor - Model Number Mower Deck165892 Mower Housing 165723 Illc 71idx1.15odx.030thk Flywheel f Control KEY NO. Partno IGNiTiON Coil Cylinder Head Labels Exhaust Pipe KEY NO. Part no Description Page Suggested Guide for Sighting Slopes for Safe Operation Your Home

917.2738 specifications

The Craftsman 917.2738 is a versatile and reliable lawn tractor designed for homeowners seeking an efficient solution for yard maintenance. This lawn tractor combines power, durability, and user-friendly features, making it an ideal choice for those with medium to large-sized lawns.

One of the standout features of the Craftsman 917.2738 is its robust engine. Powered by a reliable Briggs & Stratton engine, it provides the necessary torque and performance to tackle a variety of mowing tasks. The engine is designed for easy starting and dependable operation, ensuring that users spend less time worrying about maintenance and more time enjoying their landscaped surroundings.

The cutting deck of the Craftsman 917.2738 is another key feature, boasting a 42-inch size that allows for efficient mowing of large areas. The cutting height can be easily adjusted, offering users the flexibility to choose from multiple settings to suit their lawn’s needs. This feature not only enhances cutting performance but also promotes a healthier lawn by allowing for optimal grass growth.

Additionally, the tractor incorporates a hydrostatic transmission, which offers a smooth and intuitive driving experience. This technology removes the need for shifting gears, enabling operators to maintain control while navigating tricky terrain or tight spots. The responsive steering and maneuverability enhance the overall usability, making it easy for users to navigate around flower beds, trees, and other obstacles.

Another characteristic of the Craftsman 917.2738 is comfort and ergonomics. The tractor features a comfortable operator seat with ample padding, allowing users to mow for extended periods without discomfort. The easy-to-reach controls provide convenience and make operating the mower straightforward for both experienced gardeners and beginners alike.

Durability is an essential aspect of the Craftsman brand, and the 917.2738 lives up to this reputation with its sturdy chassis and high-quality materials. This ensures that the tractor can withstand regular wear and tear, making it a dependable choice for long-term lawn care.

Overall, the Craftsman 917.2738 combines powerful performance, innovative features, and comfort, making it a great investment for homeowners looking to efficiently maintain their lawns. With its balanced design and high-quality engineering, it stands out as a reliable workhorse in the realm of lawn tractors.
Top Page Image Contents