| Screws | Spring | Electric |
Left Hand | Idler | ||
Mandrel | Pulleys |
| Clutch |
|
|
| Pulley |
Cover | Primary |
|
|
| Idler Arm |
|
|
| II |
|
|
t | Bolt in | |
Mower | ||
'"J | ||
_7 / | Housing |
Left
Hand
Mandrel
Mower
Drive Belt
Belt
Keepers
TO REPLACE MOWER BLADE DRIVE BELT
Park the tractor on level surface. Engage
parking brake.
•Remove mower drive belt (See "TO REPLACE MOWER DRIVE BELT" in this section of this manual).
•Remove mower (See "TO REMOVE
MOWER" in this section of this manual).
•Remove screws from R.H. mandrel cover and remove cover. Unhook spring from bolt on mower housing.
•Carefully roll belt off R.H. mandrel pulley.
•Remove belt from center mandrel pulley, idler pulley, and L.H. mandrel pulley.
•Remove any dirt or grass which may have accumulated around mandrels and entire upper deck surface.
•Check secondary idler arm and idler to see that they rotate freely.
•Be sure spring is hooked in secondary idler arm and
•Install new belt in lower groove of L.H. mandrel pulley, idler pulley, and center mandrel pulley as shown.
•Roll belt over R.H. mandrel pulley. Make sure belt is in all grooves properly.
•Reconnect spring to bolt in mower housing and reinstall R.H. mandrel cover.
•Reinstall mower to tractor (See
"INSTALL MOWER AND DRIVE BELT"
in the Assembly section of this manual).
•Reassemble mower drive belt (See
"TO REPLACE MOWER DRIVE BELT" in this section of this manual).
Left |
|
| Center |
Hand | Mower Blade | Mandrel | |
Mandrel | Drive Belt / | Right Hand | |
|
| / | Mandrel |
|
|
| |
,- | _ |
| Cover |
Secondary | _'. | 5, |
Idler Arm | _;: | ;. ' |
Sprin, | Pulley Sc re/w | |
Bar Bracket |
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years of service. The clutch has a
that stops the pulley within 5 seconds.
25