Craftsman 917.271641 owner manual To Operate Mower, To Transport, To Operate on Hills, Ments

Page 14

The average lawn should be cut to

approximately 2-1/2 inches during the cool season and to over 3 inches

during hot months. For healthier and better looking lawns, mow often and after moderate growth.

For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut

relatively high; the second to desired height.

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

1.Select desired height of cut.

2.Start mower blades by engaging attachment clutch control,

TO STOP MOWER BLADES - disengage attachment clutch control.

,_CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector

shield in

place.

 

Attachment

Attachemnt

 

 

Lever

"Engaged"

 

High

Position

/

: Position

 

Position

Position

Deflector

 

IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is de- pressed.

To restart movement, slowly release parking brake and clutch/brake pedal.

Slowly move motion control lever to slowest setting.

Make all turns slowly.

TO TRANSPORT

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free whee_ control is Ioc_,ted at the rear drawbar of tractor.

1.Raise attachment lift to highest position with attachment lift control.

2.Pull freewheel control out and down into the slot and release so it is held in

the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on e truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TO OPERATE ON HILLS

A_CAUTION: Do not drive up or do.wq hills with slopes greater than 15 0 ana ao

not drive across any slope.

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If slowing is necessary, move throttle control lever to slower position.

If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

Move motion control lever to neutral (N) position.

TOWING CARTS AND OTHER ATrACH-

MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy o{ a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

14

Image 14
Contents ICRnFT Mrwi Back Cover SafetyLimited 90 DAY Warranty on Battery Do not General OperationII. Slope Operation IV. Service IlL ChildrenPage Repair Agreement ProductspecificaonsAmps Headlights Customer ResponsibilitiesSteering WheelInsert To Removetractor from Carton Unpack Carton Tools Required for AssemblyHowto SET Upyourtractor Install Seat Release parking brake by depressing clutch/brake pedalInstall Mulcher Plate @@@@@ Knowyourtractor To USE Throttle Control To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking Brake To Move Forward and BackwardTo Operate on Hills To Operate MowerTo Transport MentsTo Start Engine Before Startingthe Engine Check Engine OIL LevelADD Gasoline Move throttle control to choke positionPurgetransmission Automatic Transmission Warm UPMowingtips Mulching MowingtipsGeneral Recommendations Lubrication ChartMaintenance Schedule Before Each USETires BatteryTractor Operator Presence SystemTransaxle Pump Fluid BeltsTransaxle Cooling Engine LubricationTo Service PRE-CLEANER Clean AIR ScreenSpecifications Engine Cooling FinsTractor CleaningTo Install Mower To Remove MowerGround SIDE-TO-SIDE AdjustmentMower to Tighten nut E on both front links an equa number of turnsDepress clutch/brake pedal and engage parking brake To Adjust BrakeTo Replace Mower Blade Drive Belt Becomes 1-9/16. Retighten jam nut against nut aTo Start Engine with a Weak Battery Transaxle Motion Control Lever Neutral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAIJREPLACE- MentInterlocks and Relays Replacing BatteryTo Replace Headlight Bulb To Replace FusePreliminary Setting To Adjust Throttle Control CableTo Adjust Carburetor EngineAcceleration Test Cylinders Engine Fuel SystemEngine OIL OtherCorrection Troubleshooting ChartProblem Cause Problem Problemcause Schematic Tractor --MODEL NumberTractor --MODEL Number 917,271641 ElectricalElectrical Tractor --MODEL Number 917.271641 Chassis and Enclosures Tractor - Model Number 917.271641 Chassis and Enclosures Bolt, CarriageIhal I UII- MUUI-LNUNIt-II 11f.Z/1t41 TRACTOR--MODEL Number Ground Drive 25/32Tractor - Model Number 917.271641 Steering Assembly Steering Assembly TRACTOR--MODEL NumberSpark Arrester Tractor - Model Number 917,271641Optional Equipment Inch= 25,4 mm Seat Assembly HA. I UH - Muuil NU MII- HDecals Wheels &TIRESLift Assembly 3219Tractor -- Model Number Lift Assembly TRACTOR--MODEL Number Mower Deck 917.271641Tractor --MODEL Number Mower Deck KEY Part DescriptionTractor - Model Number Hydro Transaxle - Model Number ID X 40MM Specialtools To NSTALL. see Repair Instruct On Manual ++ l 287 462 801LABEL*EMISSIONS 52415` Tractor - Model NumberTlA., tuft - MULJt. NUMtH 917,27141 692226Fan-Flywheal Page Suggested Guide for Sighting Slopes for Safe Operation Get it fixed, at your home or ours