Craftsman 917.27086 manual Mulching Mowing Tips

•Sitting in the traotor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. W'dh motion control lever in neutral (N) position, slowly disengage clutch/ brake pedal.

•Slowly move motion control lever forward, after the tractor moves

approximately five (5) feet, slowly move motion control lever to reverse

position. After the tractor moves approximately five (5) feet return the motion control lever to the neutral (N) position. Repeat this procedure with the motion control lever three (3) times.

•Your tractor is now purged and now ready for normal operation.

MOWING TIPS

•Mower should be properly leveled for best mowing performance. See =TO

LEVEL MOWER HOUSING" in the

Service and Adjustments section of this manual.

•The left hand side of mower should be used for trimming.

•Drive so that clippings are discharged onto the area that has been cut. Have

the cut area to the right of the tractor. This will result in a more even distril_u- tion of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings wilt discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand tums until finished.

•If grass is extremely tall, it should be mowed twice to reduce load and

possible fire hazard from dried clippings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

•Always operate engine at full throttle when mowing to assure better mowing performance and proper discharge of material. Regulate ground speed by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

•When operating attachments, select a

•ground speed that will suit the terrain and give best performance of the attachment being used.

1

MULCHING MOWING TIPS

IMPORTANT: For best performance, keep mower housing free of built-up grass and trash. Clean after each use.

•The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to I_rovidenutrients for the lawn.

Always mulch with your highest engine (blade) speed as this will

provide the best recutting action of the blades.

•Avoid cutting your lawn when it is wet.

Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried and the newly cut area will not be exposed to the direct sun.

•For best results, adjust the mower cutting height so that the mower cuts off only the top one-third of the glass blades. For extremely heavy mulching, reduce your width of cut on each pass and mow slowly.

•Certaintypas of grass and grass conditions may require that an area be mulched a second time to completely hide the clippings. When doing a second cut, mow across or perpen- dicular to the first cut path.

•Change your cutting pattern from week to week. Mow north to south one week

then change to east to west the next week. This will help prevent matting and graining of the lawn.

Max 1/'3"

17