Craftsman 917.27077 manual Tolevelmowerhousing, FRONT-TO-BACK Adjustment, SIDE-TO-SIDE Adjustment

Page 22

TOLEVELMOWERHOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See =PROD-

UCT SPECIFICATIONS" section of this manual). If tires are over or underinflat- ed, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of

mower to ground. Distance =A" on both sides of mower should be the same or

within 1/4" of each other.

•If adjustment is necessary, make adjust- ment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift

link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

Bottom Edge of

Bottom Edge of

Mower to Ground

Mower to Ground

•Before making any necessary adjust- ments, check that both front links are equal in length. Both links should be approximately 10-3/8".

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut "E" on both front links an equal number of turns.

•When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts =P against trunnion on both front links.

•To raise front of mower, loosen nut =P from trunnion on both front links.

Tighten nut =E" on both front links an equal number of turns.

•When distance "D" is 1/8" to 1/2" lower

at front than rear, tighten nut =P against trunnion on both front links.

•Recheck side-to-side adjustment.

Mandrel

qooo

Both Front Links Should be Equal in Length

_o_ Suspensi°n

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side-to- side. If the following front-to-back adjust- ment is necessary, be sure to adjust both

front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower housing should be adjusted so that

the front is approximately 1/8" to 1/2" lower than the rear when the mower is in

its highest position.

Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.

TmnnionNUt"P..____

_ut

"E"

Front Links

TO REPLACE MOWER BLADE DRIVE BELT (See Illustration Next Page)

The mower blade drive belt may be replaced without tools. Park the tractor on level surlace. Engage parking brake.

BELT REMOVAL -

•Remove mower from tractor (See =TO

REMOVE MOWER" in this section of this manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents RRIIFTSMIIN Limi Warraniy on Craftsman Riding Equipment General OperationSlope Operation ServiceChildren Do notNevermakeadjustmentsor repairswith the enginerunning TY is InvolvedMaintenance Agreement Product SpecificationsCustomer Responsibilities Parts BAG Contents Shown Full Size @@ , Washers Tools Required for Assemble Extension Shaft and BootInstall Steering Wheel To Remove Tractor from CartonInstall Mulcher Plate HOW to SET UP Your Tractor Connect BatteryInstall Seat Assemble Gauge Wheels to Mower DeckCheck for Proper Position of ALL Belts H L Attachment Stopping HOW to USE Your TractorTo SET Parking Brake EngineTowing Carts and Other Attachments ToadjustmowercuttingheightBefore Starting Engine Warm Weather Starting 50 F Above ADD GasolineTo Start Engine Cold Weather Starting 50 F and belowMowing Tips Mulching Mowing TipsGeneral Recommendations Lubrication ChartBefore Each USE Tractor BrakeoperationTransaxle Cooling EngineCleaning To Install Mower To Remove MowerSIDE-TO-SIDE Adjustment TolevelmowerhousingFRONT-TO-BACK Adjustment Belt RemovalTo Adjust Brake Am NutTo Start Engine with a Weak Battery To Adjust Steering Wheel AlignTo Adjust Throttle Control Cable Replacing BatteryTo Adjust Choke Control Final SEI-IING To Adjust CarburetorPreliminary Setting Acceleration TestEngine OIL TractorFuel System CylindersProblem Troubleshooting ChartCause Correction Problemcause Correction Troubleshootinghart Problem Cause=FAST Schematic Tractor - Model NumberTractor - Model Number ElectricalTractor - Model Number ElectricalTractor - Model Number Chassis and Enclosures KEY Part NO. NO.DESCRIPTION Tractor - Model Number Ground Drive Tractor - Model Number Ground Drive KEY Part NO. no DescriptionTractor - Model Number Steering Assembly Tractor - Model Number 917,270770 Steering Assembly KEY Part NO. NO. DescriptionEngine Engine KEY Part NO. NO. Description 12 STD522507 Bolt RrHex 1/4Tractor - Model Number Seat Assembly KEY -PART NO. noWheels & Tires DecalsKEY Part DESCRIP11ONTractor - Model Number Lift Assembly KEY Part Description Tractor - Model Number Mower Deck KEY Part Description Stlt150 792077A 535 Gasket SET J Tractor o Model Number Label Kiti 51A 281412 Spacer, Carburetor Inch= 25.4 mm 859 Page Page Page Suggested Guide for Sighting Slopes for Safe Operation Sears

917.27077 specifications

The Craftsman 917.27077 is a versatile and powerful garden tractor designed for homeowners who seek performance, reliability, and ease of use in their lawn care equipment. Engineered with a robust build and advanced technologies, it caters to a wide range of outdoor tasks, from mowing to hauling.

One of the standout features of the Craftsman 917.27077 is its 24-horsepower Kohler engine. This powerful engine delivers the necessary torque for efficient cutting and handling of various terrains, making it suitable for both flat lawns and hilly landscapes. The reliable engine is known for its longevity and low maintenance requirements, ensuring that homeowners can rely on it for many seasons.

Another significant aspect of the 917.27077 is its 42-inch cutting deck. This size strikes a perfect balance between maneuverability and mowing efficiency, allowing users to cover substantial ground while easily navigating through tight spaces and around obstacles. Equipped with cutting height adjustments, the deck can be set to different positions, providing flexibility for achieving the desired grass height.

The garden tractor also features a hydrostatic transmission, which offers smooth and user-friendly operation. Unlike traditional gear systems, hydrostatic transmissions allow for seamless speed and direction changes without the need to shift gears. This functionality enhances user comfort, especially during lengthy mowing sessions, making the Craftsman 917.27077 an excellent choice for homeowners.

In terms of characteristics, the Craftsman 917.27077 is designed with an ergonomic seat that ensures comfort during use. The adjustable seat can accommodate various user heights, ensuring a comfortable grip on the steering wheel for optimal control. Additionally, the tractor features a user-friendly control panel with intuitive controls for easy operation.

Another noteworthy feature is the built-in mulching capability. This technology allows for the grass clippings to be finely chopped and returned to the lawn as natural fertilizer, promoting a healthier grass ecosystem. This not only saves time but also reduces waste, making it an environmentally friendly choice.

Overall, the Craftsman 917.27077 exemplifies a well-rounded garden tractor that combines power, comfort, and innovative technology. Whether tackling routine lawn maintenance or more demanding landscape tasks, this garden tractor provides reliability and performance that homeowners can depend on. Its user-friendly features and advanced characteristics make it a valuable addition to any outdoor toolkit.
Top Page Image Contents