Setting up Lift Mounting Hardware
Tractor Lift can be used out of the box on all Craftsman tractors with bumpers or brush guards. For tractors without bumper or brush guard, Tractor Lift mounting hardware is provided. Follow the steps below:
6
31
32
Front
IlXll
Remove,
add washer ( 24 ), replace.
6
Rear
Remove existing bolt "X" and set aside. If tractor does not
have this bolt, use supplied 3/8" x
Insert bolt ( 29 ) through inside front hole of frame, through tractor bracket ( 7 ) and secure with nyloc nut ( 27 ).
Add flat washer ( 24 ) under head of bolt removed in earlier step and reinsert through tractor mounting bar and tighten.
For LT1000 & LT2000 series tractors, use
Slide lifting bar ( 6 ) through
Pin lifting bar in place with one hairpin cotter ( 26 ) on each side, inside of tractor brackets ( 7 ).
Place lifting bar ( 6 ) under rear tractor hitch and slide threaded stud through hole.
Secure in place with flat washer ( 32 ) and hex nut ( 31 ).
FOR MISSING PARTS, Call
Page 5.