| SERVICE AND |
BOTTOM EDGE | BOTTOM EDGE |
OF MOWER TO | OF MOWER TO |
GROUND | GROUND |
FIG. 21
_(_ SUSPENSIONARM
. /
LIFT LiNK ADJUSTMENT NUT
FIG_ 22
IMPORTANT: DECK MUST BE LEVEL
NECESSARY, BE SURE TO ADJUST BOTH FRONTLINK8 EQUALLY SO MOWER WILL STAY LEVEL
SIDE,
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 118"to 1/2" lower than the rear when the mower is in its highest position,
Check adjuslment on right side of tractor Measure dis- tance "D" directly in front and behind the mandrel at boltom edge of mower housing as shown
•Before making any necessary adjustments, check that both fron! links are equalin tenglh Both links should be approximately
•tf links are not equal in length, adjust one link to same Ieng[h as other link,
•To lower front of mower loosen nut "E" on both front links an equal number of turns
•When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links.
•To raise front of mower, loosen nut"F" from trunnion on both front links. Tighten nut "E" on both front links an equal number ol turns
•When distance "D" is 1/8" to 1/2" lower at front than • rear, tighten nut"F" against trunnion on both front links. Recheck
:,_,,,% | t | _ =,_ MANDREL |
FIG, 23
iii, i, | IIIIHIIlll | ii |
ADJUSTMENTS
BOTHFRONT LINKSMUSTBE EQUALIN LENGTH
NUT "E"
NUl
FIG. 24
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL (See Fig, 25)
,Park!rector on a level surface Engage parking brake.
• Remove four screws from L,H mandrel cover and remove cover,
• Roll beIt over the top of L H, mandrel pui_ey,
• Remove belt from electric clutch pulley.
• Remove belt from tdter pulleys,
Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck surface,
•Check primary idler arm and two idlers to see that they rotate freely,
•Be sure spdng ts securely hooked to primary idler arm and bolt in mower housing,
MOWER DRIVE BELT INSTALLATION (See Fig, 25)
•Install be{t in both idlers, Make sure belt. is in both belt keepers at the idlers as shown
•Install new belt onto electric cFutch puItey,
•Roll belt into upper groove ol LH mandrel pulley
. Carefully check bell routing making sure belt ls in the grooves correctly and inside belt keepers Reassemble LH. mandrel cover
ELECTRIC
CLUTCH
PULLEY
22 | FIG. 25 |