Craftsman 917272673 owner manual Battery, Tractor, Fuel System, Engine OIL, Cylinders

Page 27

Immediately prepare your tractor for stor- age at the end of the season or if the trac- tor will not be used for 30 days or more. _)_WARNING: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open flame

or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear.

Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected -

and battery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in

the Maintenance section of this manual).

After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture

which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the

fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car- buretor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in

the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors

and cover it to give protection from dust and dirt.

Cover your tractor with a suitable pro- tective cover that does not retain mois-

ture. Do not use plastic. Plastic cannot breathe which allows condensation to

form and will cause your tractor to rust. IMPORTANT: Never cover tractor while

engine and exhaust areas are still warm.

27

Image 27
Contents ICRAFT, MnN ,I Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentII. Slope Operation Wash hands after handlingIV. Service Do notIII. Children 1st Product SpecificationsSears Installation Service Istomer ResponsibilitiesRepair Protection Agreements Seat KeysVideo Cassette Before Removing Tractor from Skid Attach Steering Wheel Tools Required for AssemblyInstall Seat To Remove Tractor fromLift seat pan to raised position Check BatteryCheck Brakesystem Install Mulcher PlateTo Convert to Bagging or Discharging Check for Proper Position of ALL BeltsResult in death, serious injury and/or property damage Plunger Know Your TractorTo USE Throttle Control HOW to USE Your TractorStopping EngineTowing Carts and Other ATTACH- Ments Before Starting the EngineTo Operate on Hills To TransportTo Start Engine Mulching Mowing Tips Mowing TipsPivots Lubrication ChartGeneral Recommendations Before Each USEBlade Care BatteryBrake Operation Operator Presence SystemAIR Filter Transaxle CoolingBelts Engine LubricationIN-LINE Fuel Filter CleaningMuffler Spark PlugsTo Install Mower TractorTo Remove Mower Belt Removal To Level Mower HousingSIDE-TO-SIDE Adjustment To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt To Start Engine with a Weak BAT Transaxle Gear Shift Lever NEU- Tral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Remove Hood and Grill AS- Sembly Replacing BatteryDo not short battery To Replace Headlight BulbFinal Setting To Adjustthrottle Control CableTo Adjust Carburetor Preliminary SettingEngine OIL BatteryTractor Fuel SystemCorrection ProblemWeak or dead battery CausePoor cut uneven Troubleshooting ChartLoss of power Excessive vibration Faulty operator-safety presence control systemProblemcause White Tractor -- Model Number SchematicElectrical Tractor - ModelElectrical 74760412 Bolt Hex Hd 1/4-20 Unc x 3/4175688 Chassis-Laser-It.stlt27 Tractor - Model Number 917.272673 Chassis and EnclosuresHood/Dash Chassis and Enclosures197 Tractor - Model Number Ground DriveTractor - Model Number Ground Drive Tractor - Model Number Insert, Steering Wheel 1397686266H 30 STD561210 40 7810H 41 100711LTractor -- Model Number 8113Arrester 16-18 Unc 17000616 Screw 16 x 1-1/2 STD541431 Nut 19131614 Tractor - Model Number 917.272673 Seat AssemblyWheels &TIRES Tractor - Model Number DecalsTractor - Model Number Lift Assembly 122365X Button, Plunger, RedLink, Lift, L.H Tractor -- Model Number Mower Deck 156 151142 Unc x Mower Deck139888 Deflector883 706A 778309 790079780086A Bearing 5/8 792073A524 842€ 1266 2272o,0 93I 1266 95e634 1266A O 3101 1005Tractor Model Number 917.272673Briggs ENGINE-MODEL Number 31C707, Type Number 0230-E1 Number 0230-E1 Briggs ENGINE-MODEL Number 31C707,TYPEPage Suggested Guide for Sighting Slopes for Safe Operation SE/ARS

917272673 specifications

The Craftsman 917272673 is a powerful and versatile lawn tractor designed for homeowners seeking a reliable solution for lawn maintenance. This robust machine combines functionality with innovative technology, making it an essential addition to any garden or yard.

One of the standout features of the Craftsman 917272673 is its potent engine. Powered by a reliable 24 HP V-Twin Kohler engine, it delivers the necessary torque and power to handle various cutting conditions. This engine ensures efficient performance, whether you're tackling tall grass or dealing with uneven terrain. The hydrostatic transmission also enhances ease of use, allowing for smooth acceleration and seamless transitions between speeds without the need for manual gear shifts.

The design of the Craftsman 917272673 promotes user comfort and support. The adjustable high-back seat provides ample support during lengthy mowing sessions, ensuring that users remain comfortable while navigating their lawns. Additionally, the ergonomic steering wheel and easy-access controls simplify the driving experience, allowing for precise maneuverability around obstacles like flower beds and trees.

The cutting deck is another remarkable feature of this lawn tractor. With a 46-inch cutting width, users can cover significant ground efficiently. The deck’s dual-blade system not only enhances cutting performance but also provides a clean and even cut. The cutting height can be easily adjusted through six different positions, allowing for personalized lawn care that caters to various grass types and growth heights.

Furthermore, the Craftsman 917272673 includes technological advancements such as a reinforced steel frame, making it durable enough to withstand regular use and the wear and tear of outdoor conditions. The tractor is also equipped with a built-in mulching capability, enabling users to finely chop grass clippings and return them to the soil, promoting healthy grass growth while minimizing waste.

Maintenance is simplified with features like an easy-access oil filter and engine access, which makes routine checks and servicing hassle-free. This commitment to user-friendly maintenance ensures that the Craftsman 917272673 remains in peak condition for many mowing seasons.

With its combination of power, comfort, and advanced technologies, the Craftsman 917272673 is a top choice for homeowners looking for an effective lawn care solution that blends performance with convenience. Whether you own a small yard or a larger landscape, this lawn tractor is poised to meet diverse mowing needs efficiently.