Assemblethe engine base assembly to the welded angles on the tongue using four 5/16" x 3/4" hex bolts, 5/16" lock washers and 5/16'hex lock nLRs. NOTE:
Use the upper set of holes in the welded angles. Make sure bolts are securely tightened. See figure 20.
| ENGINE |
| BASE |
| 5EMBLY |
| 5/16" LOCK |
, | WASHER |
I' |
|
5/16" HEX LOCK | 16" x 3/4" |
| HEX BOLT |
RF.AR | l |
| |
WELDEDANGLES | FRONT |
i |
|
FIGURE 20 |
|
To assemble the hose hanger bracket to the blower
housing,you mustfirst remove two self tapping screws from the holes in the blower housing as shown
in figure 21. Using these same screws, attach the hose hanger bracket to the blower housing.
5/16" x 3/4" SELF TAPPING SCREWS
HOSE
HANGER
BRACKET
Mount the chipper chute assembly onto the three weld bolts located on the back side of the blower
housing assembly. Fasten with three 5/16" bell washers (cupped side against chute assembly) and three 5/16" lock nuts. Tighten securely. See figure 22.
CHIPPER CHUTE
ASSEMBLY
5/16" WELD BOLTS
(FOUND ON BACK
5/16" LOCK NUT
/
.--'"_'_ 5116" BELL WASHER
'FIGURE22
•Assemble the eibow to the blower housing, using four 5/16" x 3/4' self tapping hex bolts, and four nylon washers. Tighten bolts securely. See figure 23.
NYLON
WASHER
5/16" x 3/4"_
(SELF TAP)
HEXBOLT [
FIGURE 21 | FIGURE 23 |
12