USING THE CHIPPER CHUTE
•Material such as stalksor heavy branches up to 3" in
diameter may be fed intothe chipperchute as shown in figure 37.
•Be sure to wear eye protection and gloves when feeding material into the chipper chute.
•Use the tamper plug, not your hands, to force material down through the chipper chute.
For best performance, it is important to keep the chipper blades sharp. If the compositionof the material being discharged changes (becomes stnngy, etc.) or if the rate of discharge slows down consider- ably, it is likelythat the chipper blades are dull and need to be sharpened or replaced. Refer to the Service and Adjustments section, on page 21.
&
&
WARNING: Do not attempt to feed an_i material larger than 3" in diameter into
the chipper chute. Personal injury or damage to the machine could result.
DANGER: Keep hands out of chipper
chute. Rotating blades in impeller
housing can cause serious injury. Use the tamper plug to help push material clowninto the chute.
FIGURE 37
19