Assembly, Assembling the handle, Fit Accu

Do not touch battery acid.

If acid comes in contact with the eyes, wash

out immediately with water and send for a doctor.

3. Assembly

1.	Insert lower part of bottom upright 1	1
	into upright holders 2 up to stop and	1	2
	into upright holders 2 up to stop and
	secure with the screws 3.
	secure with the screws 3.	3
2.	Push connector 4 from underneath	3
	into upper part of bottom upright 1.

3.	Insert threaded rod 6 from left through
	lower parts of central upright 5,
	upper part of bottom upright 1 and
	connector 4 right up to the stop.	6
4.	Slide threaded bearing 8 into	6
4.	Slide threaded bearing 8 into
	clamping lever 7.

5. Screw clamping lever 7 onto threaded rod 6 approx. 4 turns.

7.If clamping lever 7 does not yet lock, screw another turn onto threaded rod 6. Repeat procedure

until clamping lever 7 locks on

connector 4.

8 Firmly attach bottom part of top

upright 9 to upper parts of central 4 7 upright 5 using 2 wing nuts zm .

The safety starter lock B on the crossbar 9 must then be on the left.

9. Fix the motor cable 0 to the upright with the two cable clips A.

Warning! Short-circuit – fire risk !

C	The Accu is supplied charged at the factory but may lose charge if
	it has been stored for a long time. Charge the Accu before using it
	for the first time (see 7. Maintenance Charging the Accu).

D	F	E	1.	Press Accu cover C lightly at the front and open.
D	F	E	2.	Insert the Accu D into the Accu compartment with the connec-
			2.
				tions pointing towards the flat plugs E.

Warning !

AThe polarity +/ - and the colours of the connections on the Accu and the flat cable must match.

V Connect flat cable E to the Accu connections, matching the terminals (see adhesive label on the Accu).

1. Secure Accu D with the retaining strap F.

2. Close Accu cover C.