OPERATUO
TO OPERATE MOWER (See Fig. 10)
Your tractor is equipped with an operator presence sens- ing switch° Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
•Select desired height of cut
,,Lower mower with attachment lift control
•Start mower blades by engaging attachment clutch control
•TO STOP MOWER BLADES - disengage attachment clutch control,
without either the entire grass catcher, CAUTION:on mowers Doso notequipped,operate orthethemowerdis- charge guard in place.
i | i | l i, | i H | ii | i | i | ii | i | i i ,i |
ATTACHMENT CLUTCH LEVER
"DISENGAGED" POSITION
"ENGAGED"
POSITION ATTACHMENT LEVER
HIGH POSITION
DISCHARGE
GUARD
FIG. 10
TO OPERATE ON HILLS
|
|
|
| i,,,i ,,,,,ll | lira ii i |
| i |
I | ,_ | CAUTION: | Do | not | drive | up or down | i |
i | ,_ | hills with slopes | greater | than 15° and | ! | ||
I | _ | do not drive | across | any | slope. | ||
•Choose the slowest speed before starting up or down hills
°Avoid stopping or changing speed on hills.
•If slowing is necessary, move throttle control lever to slower position.
. If stopping is absolutely necessary, push clutch/brake
pedal quickly to brake position and engage parking brake.
•Move motion control lever to neutral (N) position..
IMPORTANT: THE MOTION CONTROL LEVER DOES
NOT RETURN TO NEUTRAL (N) POSITION WHEN THE CLUTCH/BRAKE PEDAL IS DEPRESSED°
"To restart movement, slowly release parking brake and clutch/brake pedal
oSlowly move motion control lever to slowest setting o Make all turns slowly.
TO TRANSPORT (See Figs. 8 and 11)
When pushing or towing your tractor, be sure to disengage
transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.
•Raise attachment lift to highest position with attach- ment lift control
•Pull freewheel control knob out and hold in position by inserting retainer spring into forward hole of control rod.
oDo not push or tow tractor at more than two (2) MPH. ', To reengage transmission, reverse above procedure.
NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).
FIG. 1 1
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL (See Fig. 17)
,,The engine in your tractor has been shipped, from the factory, already filled with summer weight oil
. Check engine oil with tractor on level ground
oRemove oil filt cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until "FULL" mark on dipstick is reached.. Do not overfill.
°For cold weather operation you should change oil for easier starting (See "OIL VISCOSITY CHART" in the Customer Responsibilities section of this manual)_
•To change engine oil, see the Customer Responsibili- ties section in this manual,
13