| == =,,,m | =,,, |
|
| ASSE |
utuuu,tt | = un | m, |
°Connect BLACK grounding cable to negative
•Close battery box door. Open battery box door for:
°Inspection for secure connections (to tighten hard- ware)
,,Inspection for corrosion, - Testing battery
• Jumping (if required)°
• Periodic charging.
DISCARD TERMINAL
PROTECTIVE CAPS
m ,,, v | = | = |
LY
=Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down,
-Get off seat without moving its adjusted position,
• Raise seat and tighten adjustment bolt securely.
SEAT
SEAT PAN
SHOULDER
BOLT _ _
LARGEFLAT WASHER
ADJUSTMENT
LOCK WASHER
BOLT
"LOCK WASHER
| \ |
POSITIVE | NEGATIVE |
(RED) CABLE | (BLACK) CABLE |
FIG. 2
SEAT
PAN
BOX DOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before fightenfflg adjustment bolt
•Remove cardboard packing on seat pan.
Place seat on seat pan and assemble shoulder boil
•Assemble adjustment bolt, tock washer and flat washer loosely. Do not tighten.
*Tighten shoulder bolt securely,
•Lower seat into operating position and sit on seat.
FIG. 4
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for shipping purposes Correct tire pressure is important for best cutting performance.
•Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" or] page 3 of this manual,
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly leveled, See "TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual
CHECK FOR PROPER POSrf'lON OF ALL BELTS
See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual. Verify that the belts are routed correctly,
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that the brake is properly adjusted. See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual
ASSEMBLE GAUGE WHEELS TO MOWER DECK (See Fig. 5)
Assemble gauge wheels with tractor on a fiat level surface,
°Adjust mower to desired cutting height (See "TO AD- JUST MOWER CUTTING HEIGHT" in the Operation section of this manual),
oWith mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the
ground_ lnstatl gauge wheel in appropriate hole with shoulder bolt, 3/8 washer and
-Repeat for opposite side installing gauge wheel in same adjustment hole.
8