AB Soft 6424 Corner Shelf 2 pack, 0130 30” Shelf Kit w/ hardware 3 pack, Shelf Support Channel

Page 14
following Shed Accessories:

Enhance your Lifetime® Outdoor Shed by purchasing the

following Shed Accessories:

Model #

0110 Corner Shelf (2 pack)

Two 10” radius shelves with hardware.

0130 30” Shelf Kit w/ hardware (3 pack)

Three 30” x 10” Steel-Reinforced Shelves with shelf brackets and hardware.

0150 90” Shelf Kit w/ hardware

One 90” x 9” Steel-Reinforced Shelf with shelf bracket and hardware.

0113 16” Pegboard Strips w/ hardware

Two sixteen inch Pegboard Strips with hooks. Great for hanging large items such as: rakes, shovels, or other tools.

0190 Shelf Support Channel

Two Shelf Support Channels that allow the 30” shelves on either of the side walls of your shed.

To purchase shed accessories,

visit us at:

www.buylifetime.com

Or call:

1 (800) 424-3865

Congratulations on your Lifetime® Outdoor Shed purchase. By following the instructions below, your new Lifetime shed should provide you with years of service and enjoyment.

Cleaning and Care

The polyethylene walls and shelves are stain- and solvent resistant. To clean, use a mild soap and a soft-bristled brush. Abrasive cleaning materials may scratch the plastic and are not recommended. Repair scratches or rust spots on the metal by Sanding the affected area lightly; using a rust preventative spray primer; and finally, spraying with a high-gloss spray enamel paint. Avoid placing a direct heat source on or near surfaces unless using a heat

barrier.

For warranty details or to register your product, visit

www.lifetime.com or call 801-776-1532

14

Image 14
Contents O U T D O O R S T O R A G E OUTDOOR STORAGE BUILDINGMODEL 30” OUTDOOR STORAGE EXTENSION KIT SAFETY INSTRUCTIONS A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLYBEFORE BEGINNING ASSEMBLY Call Cust mer Service atIf you are Extending an Existing Shed If you are Installing a New ShedHARDWARE IS ACTUAL SIZE a. Remove the back 3 roof caps Save all hardware for re-assemblya. Remove last three skylights a. Remove the Roof Truss a. Remove the last two Side Wall Panels 8 Assemble Window a. Add Wall Panels 11 Assemble Truss The nut goes on outside of the trussTD TB TB Do not overtighten the Cap NutRoof Panel Ridge Roof Panel Wall a. Add Trussa.Add Roof Panels 114 and Roof Supports AD b. Add a center Roof Capa. Add next Truss a. Add Skylights 0150 90” Shelf Kit w/ hardware 0110 Corner Shelf 2 pack0130 30” Shelf Kit w/ hardware 3 pack 0113 16” Pegboard Strips w/ hardware