AB Soft 6424 manual Assemble Window

Page 7

8 Assemble Window

8 Assemble Window

TF (1)

	a. Remove plastic sheeting from Window (AE) and slide Window into slot	TH (4)
	on the Window Wall Panel (125). Attach a Window Latch (TK) above each	TH (4)
	corner of the Window as shown. When tightening screws (TH), be sure
	that Window Latches will slide freely. Do not overtighten. Insert screw (TF)	TK (2)
	into the hole in the window. Set panel aside.	TK (2)
	into the hole in the window. Set panel aside.

AE

Insert window with bent edge at top and pointing away from the wall.

Place Screw (TF) in this hole to keep window from sliding up too far. Insert until ﬂush with the window

7

Image 7

Contents MODEL 30” OUTDOOR STORAGE EXTENSION KIT OUTDOOR STORAGE BUILDINGO U T D O O R S T O R A G E Call Cust mer Service at A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLYBEFORE BEGINNING ASSEMBLY SAFETY INSTRUCTIONSHARDWARE IS ACTUAL SIZE If you are Installing a New ShedIf you are Extending an Existing Shed a. Remove last three skylights Save all hardware for re-assemblya. Remove the back 3 roof caps a. Remove the Roof Truss a. Remove the last two Side Wall Panels 8 Assemble Window a. Add Wall Panels The nut goes on outside of the truss 11 Assemble TrussDo not overtighten the Cap Nut TD TB TBb. Add a center Roof Cap a. Add Trussa.Add Roof Panels 114 and Roof Supports AD Roof Panel Ridge Roof Panel Walla. Add next Truss a. Add Skylights 0113 16” Pegboard Strips w/ hardware 0110 Corner Shelf 2 pack0130 30” Shelf Kit w/ hardware 3 pack 0150 90” Shelf Kit w/ hardware