AB Soft 6424 manual a. Add Wall Panels

Page 8

a.Add new Floor Panel (110). Then, slide the back section into place and connect the ﬂoor panels (you will need to tip the panels forward slightly to connect the panels).

Tip up one ﬂoor panel and line up tabs and then lay ﬂoor panel ﬂat.

a. Add Wall Panels (108).

Insert a wood block directly under the tab you want to insert, then slide block to next tab and repeat.

Image 8

Contents O U T D O O R S T O R A G E OUTDOOR STORAGE BUILDINGMODEL 30” OUTDOOR STORAGE EXTENSION KIT A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLY BEFORE BEGINNING ASSEMBLYSAFETY INSTRUCTIONS Call Cust mer Service atIf you are Extending an Existing Shed If you are Installing a New ShedHARDWARE IS ACTUAL SIZE a. Remove the back 3 roof caps Save all hardware for re-assemblya. Remove last three skylights a. Remove the Roof Truss a. Remove the last two Side Wall Panels 8 Assemble Window a. Add Wall Panels 11 Assemble Truss The nut goes on outside of the trussTD TB TB Do not overtighten the Cap Nuta. Add Truss a.Add Roof Panels 114 and Roof Supports ADRoof Panel Ridge Roof Panel Wall b. Add a center Roof Capa. Add next Truss a. Add Skylights 0110 Corner Shelf 2 pack 0130 30” Shelf Kit w/ hardware 3 pack0150 90” Shelf Kit w/ hardware 0113 16” Pegboard Strips w/ hardware