AB Soft 6424 manual a. Remove the last two Side Wall Panels

Page 6

a. Remove the last two Side Wall Panels.

Note: If you’re adding onto a side entry shed, remove the panels (in gray) from the side of the shed rather than removing the back of the shed. If you’re adding on to both sides, remove the panels (in gray) from both sides of the shed (as illustrated), and follow the remaining steps.

a.Slide the back section of the shed away from the front. You will need to tip the back section forward slightly in order to disconnect the ﬂoor panels

Be sure that there is nothing on the back shelves before moving the back section.

One person should support the back wall while it is being tipped and moved.

Image 6

Contents OUTDOOR STORAGE BUILDING MODEL 30” OUTDOOR STORAGE EXTENSION KITO U T D O O R S T O R A G E SAFETY INSTRUCTIONS A MINIMUM OF TWO ADULTS ARE REQUIRED FOR ASSEMBLYBEFORE BEGINNING ASSEMBLY Call Cust mer Service atIf you are Installing a New Shed HARDWARE IS ACTUAL SIZEIf you are Extending an Existing Shed Save all hardware for re-assembly a. Remove last three skylightsa. Remove the back 3 roof caps a. Remove the Roof Truss a. Remove the last two Side Wall Panels 8 Assemble Window a. Add Wall Panels 11 Assemble Truss The nut goes on outside of the trussTD TB TB Do not overtighten the Cap NutRoof Panel Ridge Roof Panel Wall a. Add Trussa.Add Roof Panels 114 and Roof Supports AD b. Add a center Roof Capa. Add next Truss a. Add Skylights 0150 90” Shelf Kit w/ hardware 0110 Corner Shelf 2 pack0130 30” Shelf Kit w/ hardware 3 pack 0113 16” Pegboard Strips w/ hardware