Troy-Bilt RZT 50 manual II. Slope Operation, Do not, III. Children

Page 5

13.Mow only in daylight or good artificial light.

14.Do not operate the machine while under the influence of alcohol or drugs.

15.Watch for traffic when operating near or crossing roadways.

16.Use extra care when loading or unloading the machine into a trailer or truck. This unit should not be driven up or down a ramp onto a trailer or truck under power, because the unit could tip over causing serious personal injury. The unit must be pushed manually on a ramp to load or unload properly.

17.Never make a cutting height adjustment while the engine is running if the operator must dismount to do so.

18.Wear sturdy, rough-soled work shoes and close- fitting slacks and shirts. Do not wear loose fitting clothes or jewelry. They can be caught in moving parts. Never operate a unit in bare feet, sandals or sneakers.

19.Check overhead clearance carefully before driving under power lines, wires, bridges or low hanging tree branches, before entering or leaving buildings, or in any other situation where the operator may be struck or pulled from the unit, which could result in serious injury.

20.Disengage all attachment clutches, set the parking brake in the on position, and put the lap bars to the neutral or out position before attempting to start the engine.

21.Your mower is designed to cut normal residential grass of a height no more than 10”. Do not attempt to mow through unusually tall, dry grass (e.g. pasture) or piles of dry leaves. Debris may build up on the mower deck or contact the engine exhaust presenting a potential fire hazard.

22.Use only accessories approved for this machine by Troy-Bilt. Read, understand and follow all instructions provided with the approved accessory.

II. SLOPE OPERATION

Slopes are a major factor related to loss of control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.

For your safety, use the slope gauge included as part of this manual to measure slopes before operating this unit on a sloped or hilly area. If the slope is greater than 15° as shown on the slope gauge, do not operate this unit on that area or serious injury could result.

DO:

Mow across slopes, not up and down.

Remove obstacles such as rocks, limbs, etc.

Watch for holes, ruts or bumps. Uneven terrain could overturn the machine. Tall grass can hide obstacles.

Use slow speed. Choose a low enough speed so that you will not have to stop while on the slope.

Follow the manufacturer’s recommendations for coun- terweights with attachments to improve stability.

Use extra care with grass catchers or other attach- ments. These can change the stability of the machine.

Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction. Rapid acceleration or deceleration could cause the front of the machine to lift and rapidly flip over back- wards, which could cause serious injury.

Avoid starting or stopping on a slope. If the tires lose traction, disengage the blades and proceed slowly straight down the slope.

DO NOT:

Do not turn on slopes unless necessary; if mowing slopes, turn slowly and gradually uphill, if possible.

Do not mow near drop-offs, ditches or embankments. The mower could suddenly turn over if a wheel is over the edge of a cliff or ditch, or if an edge caves in.

Do not mow on wet grass. Reduced traction could cause sliding.

Do not try to stabilize the machine by putting your foot on the ground.

Do not use the grass catcher on steep slopes.

III. CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the mowing activity. Never assume that children will remain where you last saw them.

1.Keep children out of the mowing area and in watchful care of an adult other than the operator.

2.Be alert and turn the machine off if children enter the area.

3.Before and when backing up, look behind and down for small children.

4.Never carry children, even with the blades off. They may fall off and be seriously injured or may interfere with safe machine operation.

5

Image 5
Contents OPERATOR’S Manual Important Read Safety Rules and Instructions CarefullyTractor Preparation Table of ContentsLower the Deck Discharge Chute Connect the BatteryPosition the Rear Bumper General Operation Safe Operation PracticesIII. Children II. Slope OperationDo not IV. Service Deck Height Indicator Park Brake Safety Decals and LabelsHands and Feet Safety Graphic Mower Deck Throttle Control Indicator Located on Left ConsoleSafety Decals and Labels Copy the model number here Copy the serial number here Recording Model and Serial NumberCustomer Support Slope Gauge Controls and Features Power Take-Off PTO Switch Ignition SwitchSeat Adjustment Lever Not Seen Deck Height IndexHourHour Meter Features Hour Meter/Indicator PanelIndicator Panel Features Fuel Tank CapChoke Control Throttle ControlParking Brake Engagement Lever Rear Bumper Not ShownSafety Interlock System General SafetyOperation Before Operating Your TractorCold Weather Starting Using Jumper Cables to Start EngineStarting the Engine Driving the Tractor Stopping the EnginePractice Operation Initial USE Turning the Tractor While Driving Forward Driving the Tractor ForwardTurning While Driving Rearward Driving the Tractor In ReverseStopping the Tractor Executing a Zero TurnDriving on Slopes Operating the PTOChecking the Safety Interlock Circuits Using the Mower DeckAdjusting RH & LH Drive Control Levers AdjustmentsAdjusting the Operators Seat Engine Maintenance MaintenanceHydrostatic Transmission Maintenance General Battery InformationBattery Maintenance Charging the BatteryBattery Storage Servicing Electrical SystemTractor Creeping Tire MaintenanceUsing the Transmission Bypass Rods Transmission Drive Belt Tractor High Speed TrackingTractor Storage Using a fuel stabilizerIf storing the tractor for 30 days or more Emptying the fuel systemDeck Removal Mower DeckReleasing belt tension with the idler pulley Rolling the belt off the PTO pulleyRolling the belt into the PTO pulley Deck InstallationUsing the idler pulley to tension the belt Front to Back Leveling Leveling the Mower DeckSide to Side Leveling Deck Maintenance Adjusting the Gauge WheelsUsing the Deck Wash System Cleaning the Spindle PulleysReplacing the Deck Drive Belt Mower Blade CareDeck Lubrication Page Page MANUFACTURER’S Warranty Coverage MANUFACTURER’S Limited Warranty for

RZT 50 specifications

The Troy-Bilt RZT 50 is a notable addition to the riding mower market, designed to provide both power and precision for homeowners seeking a reliable solution for lawn care. With a cutting width of 50 inches, this zero-turn riding mower allows users to tackle larger areas efficiently, making it suitable for properties with expansive lawns.

One of the standout features of the RZT 50 is its robust engine, typically powered by a 25 HP Briggs & Stratton engine. This engine delivers impressive torque and reliability, offering users the ability to handle tough mowing conditions without losing power. The mower's design prioritizes ease of use, with a trusty electric start that eliminates the hassle of manual cranking.

The RZT 50 is equipped with a dual hydrostatic drive system, which provides seamless steering and allows for easy maneuverability around obstacles such as trees, flower beds, and garden features. The zero-turn capability means that users can make tight turns without leaving uncut grass, giving the mower an edge in terms of efficiency and precision.

Another significant characteristic of the Troy-Bilt RZT 50 is its Comfort Seat, designed with ergonomics in mind. This padded, high-back seat offers support during longer mowing sessions, ensuring a comfortable riding experience. Additionally, the mower features adjustable cutting heights ranging from 1.5 inches to 4 inches, allowing users to customize their lawn care according to individual preferences and seasonal needs.

In terms of maintenance, the RZT 50 comes with a maintenance-free battery and easily accessible components for routine checks, reducing the downtime often associated with mower upkeep. Moreover, the mower boasts a durable steel frame and deck, ensuring longevity and resistance to wear over time.

Overall, the Troy-Bilt RZT 50 stands out with its combination of power, innovation, and user-friendly features, making it an ideal choice for homeowners aiming to maintain a lush and well-manicured lawn with minimal effort. With its thoughtfully designed capabilities, the RZT 50 proves that effective lawn care can be both easy and enjoyable.