S.E.P BC90(1+1) Cutting height adjustment, Knife mechanism adjustment, Cam mechanism movement

b.Loosen lock nut (5) and turn wear plate adjuster screw (4) to obtain correct sliding movement of the knife.

c.Tighten again the securing nut (5) and the screws

(1) and (2).

MOWING BAR E.S.M. type S

NOTE

The mowing bar type E.S.M. type S does not require any special adjustment as it is self-adjusting.

Cutting height adjustment

Proceed as follows to adjust cutting height (see fig. 2).

a.Loosen the two screws (1) and (2) that fasten each skid.

b.Adjust the two skids (3) as necessary to set the required cutting height.

c.Tighten again the screws (1) and (2) fastening each skid.

Knife mechanism adjustment

At regular intervals check the play between the knife and the roller.

If play becomes excessive, adjust as follows (see fig- ure 3):

a.Loosen bolts (1).

b.Turn adjuster screws (2) until play between roller

(3) and push-rod is as required.

c.Tighten bolts (1) again.

Cam mechanism movement

The coupling between roller and knife mechanism does not have adjustment; in case of excessive free play the wear parts must be substitute.

14