S.E.P BC90(1+1) manual Cutter BAR Mowers Maintenance, Lubrication

Page 18

CUTTER BAR MOWERS MAINTENANCE

MECHANICAL CON-ROD DRIVE

Lubrication

After the first 5 hours of work, and subsequently af- ter every 10 hours, grease the mower mechanism at points (1) and (2) as shown in fig.5.

CAM MECHANISM MOVEMENT

Lubrication

Greasing or lubrication points are not available in this system; it is however suggested to clean the coupling between roller and knife mechanism after its use. In order to avoid oxidation during long period of not use of the sickle bar it is suggested to lubricate roller and knife mechanism before storage.

15

Image 18

Contents BC 90 1+1 Assembling Instruction for MOTOR-MOWER MOTOR-MOWER Table of Contents Safety Regulations IntroductionGeneral Notices Operating MOTOR-MOWER MaintenanceStarting the Engine Operating of AttachmentsMOTOR-MOWER Identification Identification DataEC Marking Engine IdentificationIdentification Data Technical Specifications Safety Device Transfer Printing Instructions and SafetyMOTOR-MOWER Controls Operating the ControlsPower Take Off PTO control lever Operating the MOTOR-MOWER Stopping the EngineDRY AIR Filter MaintenanceMounting the 2ND Wheel Upon Request Gearbox and TransmissionChecks and Adjustments Clutch LeverEvery 300 hours Cutter BAR Mower Cutter BAR Mower Technical SpecificationsCutter BAR Mower Adjustment GeneralCutting height adjustment Knife mechanism adjustmentCam mechanism movement Cutter BAR Mowers Maintenance LubricationEC Certificate of Conformity Valpadana S.p.A