MOUNTING THE 2ND WHEEL (UPON REQUEST)
To mount the 2nd wheel kit, follow the below steps:
a.Insert there spacer (3) into the wheel hexagon (1) and fix it by the safety pin (4).
b.Install the second wheel (2) and fix it by its screw
(6) and washer (5).
−This procedure has to be done on both wheels.
c.Remove the oil drain plug (2) from the bottom of the gearbox (right side) and let the exhausted oil drain out. When fully drained, reinstall the plug (2).
d.Fill up with new oil (1.2 litres) of the following types:
−SAE 90 for ambient temperatures between
−SAE 140 for ambient temperatures between +32 and +60°C.
Every 20 hours
Check the level of the oil in the gearbox. The level must reach between the maximum and minimum notch on the
MAINTENANCE
To ensure continuing reliability, use only original spare parts when overhauling or repairing your mo-
ENGINE
Make sure you do comply with the safety precautions contained in the engine Operation and Maintenance Manual.
During the first 50 hours (running in)
For the first 50 hours do not use the machine for heavy duty work. The following additional instructions must also be complied with during the running in pe- riod.
DRY AIR FILTER
Every 8 hours
Clean carefully the cartridge and if is necessary re- place it.
GEARBOX AND TRANSMISSION
After the first 50 hours (running in)
Change the gear/transmission oil (see figure 13). Change the oil when the engine is hot to facilitate draining of oil.
a.Remove the left wheel.
b.Remove the oil
NOTE
Check the oil level with the motor cold and with the
11