Woods Equipment CZR2652B, CZR2242B manual Tools Required for Assembly, Uncrate Unit, Tire Pressure

Page 12

SET UP INSTRUCTIONS

WOODS

TOOLS REQUIRED FOR ASSEMBLY

-Wrecking bar

-Claw hammer

-Sockets: 1/2”, 15/16

-Wrenches: 18mm, 1/2”, 9/16”, 3/4”, 15/16”

-Tire pressure gauge

NOTE: All references below to the “right” or “left” are with respect to an operator at the controls.

1.UNCRATE UNIT

a)Discard packing materials. Loosen the caster wheel axle bolts and bumper bolts to remove the shipping brackets.

Discard shipping brackets.

b)Re-install and tighten bumper bolts.

c)Tighten caster wheel axle bolts against caster axle spanner bushings to 80 ft/lbs.

2.TIRE PRESSURE

a) Set tire pressures to 14 lbs/in2 (1.0 kg/cm2). Tires are overinflated for shipping.

3.TRACTION LEVERS

a)Tighten bolt A.

b)Sit on the machine. Levers C may be moved to upper set of holes in bar B for a better operator fit.

12

Image 12

Contents MOW’N Machine California Wash Hands After HandlingImportant Message To the DealerTo the Owner Alitec BMP Central Fabricators Gannon Gill WAIN-ROY WoodsTable of Contents FiguresSignal word definitions Become AlertSite preparation and circumstances Preparing for Safe OperationGeneral Operating SafelyStarting Mowing slopes Maneuvering SafelyMaintenance Safety FuelBattery Warning Transportation and Storage SafetyTools Required for Assembly Uncrate UnitTire Pressure Traction LeversFinal Preparations Labels Woods Read and understand Operators Manual & labels Woods Choke C Fuel Selector Valve U Lift and traction levers operators right side Pushing the Machine PRE-OPERATION Check List OPERATOR’S Responsibility Fueling Before Starting the EngineOperator Presence Interlock System Starting the EngineOperating Notes DrivingCutting Cutting TipsFirst Before Every Yearly Each HoursUSE Hours Maintenance Record Battery Check DailyLubrication Engine OIL Spark PlugsFuel Filter Dual Element AIR Cleaner Engine Cooling Specific TorquesPurging Transaxles Transaxles Transaxle Fluid ChangeBlade Installation Blade RemovalSharpening Blade BalanceDeck Leveling Height of CUTDeck Rollers Parking Brake Hydrostatic Transaxle Adjust Ments NeutralARM Rest Height Adjustments Cutterdeck Belt Belt TensionSpindle Deck Hydro Transaxle Drive Belt Page Parts Section FRAME-ENGINE/CLUTCH Assy ITM Description QTY ITM Part no Not IllustratedTransaxle Assy ITM Description QTY WasherFuel TANK/BUMPER & Control Panel Frame W/LABS Fuel Valve & Cover Plate COVER-FRAME, Rear Deck Lift Assembly WLDMT-DECKLIFT, Front Caster Assembly Dust Cover KICKPLATE/SEAT Assembly Seat Assembly Steering GRIP-HANDLE Parking Brake TRANSAXLE, RH Wire Harness HARNESS-MAIN Wire Side Discharge Deck W/LABELS To Decklift GUARD-LH 52 Deck BELTS-CUTTERDECK BELT-52 Cutterdeck Under Seat 11UNDER Footplate LABEL-CONTROL Panel Woods 4164679 Limited Warranty 8495 MM & Boundary Repair Parts Rev /15/2006 Woods Equipment Company