Woods Equipment CZR2242B, CZR2652B manual Hydrostatic Transaxle Adjust Ments, Neutral

Page 37

ADJUSTMENTS

WOODS

HYDROSTATIC TRANSAXLE ADJUST-

MENTS

A turnbuckle style hydrostat neutral adjustment is provided.

Neutral:

1.Support the machine with the rear wheels off the ground. Use jackstands or equivalent sup- port. Do not rely only on mechanical or hydraulic jacks.

2.Move the traction levers out into the neutral lock position and raise the seat.

3.Disconnect the seat switch wire and temporarily connect the two terminals with jumper wire J as shown.

4.Start the engine and run at low speed.

5.Move parking brake to the OFF position.

6.Loosen jam nuts K at both ends of the control rod L.

7.Rotate the control rod until the corresponding wheel stops turning. Lock the control rod jam nuts. Run the engine up to high idle and stroke the traction levers forward and back to check the adjustment. Move traction levers back to neutral and readjust if necessary.

8.Repeat steps 6 and 7 for the opposite side.

9.Remove the jumper wire and reconnect the seat switch.

37

Image 37

Contents MOW’N Machine Wash Hands After Handling CaliforniaTo the Dealer Important MessageTo the Owner Alitec BMP Central Fabricators Gannon Gill WAIN-ROY WoodsFigures Table of ContentsBecome Alert Signal word definitionsPreparing for Safe Operation Site preparation and circumstancesOperating Safely GeneralStarting Maneuvering Safely Mowing slopesFuel Maintenance SafetyTransportation and Storage Safety Battery WarningUncrate Unit Tools Required for AssemblyTire Pressure Traction LeversFinal Preparations Labels Woods Read and understand Operators Manual & labels Woods Choke C Fuel Selector Valve U Lift and traction levers operators right side Pushing the Machine PRE-OPERATION Check List OPERATOR’S Responsibility Before Starting the Engine FuelingOperator Presence Interlock System Starting the EngineDriving Operating NotesCutting Tips CuttingHours First Before Every Yearly EachUSE Hours Maintenance Record Check Daily BatteryLubrication Spark Plugs Engine OILFuel Filter Dual Element AIR Cleaner Specific Torques Engine CoolingPurging Transaxles Transaxle Fluid Change TransaxlesBlade Removal Blade InstallationSharpening Blade BalanceHeight of CUT Deck LevelingDeck Rollers Parking Brake Neutral Hydrostatic Transaxle Adjust MentsARM Rest Height Adjustments Belt Tension Cutterdeck BeltSpindle Deck Hydro Transaxle Drive Belt Page Parts Section FRAME-ENGINE/CLUTCH Assy Not Illustrated ITM Description QTY ITM Part noTransaxle Assy Washer ITM Description QTYFuel TANK/BUMPER & Control Panel Frame W/LABS Fuel Valve & Cover Plate COVER-FRAME, Rear Deck Lift Assembly WLDMT-DECKLIFT, Front Caster Assembly Dust Cover KICKPLATE/SEAT Assembly Seat Assembly Steering GRIP-HANDLE Parking Brake TRANSAXLE, RH Wire Harness HARNESS-MAIN Wire Side Discharge Deck W/LABELS To Decklift GUARD-LH 52 Deck BELTS-CUTTERDECK BELT-52 Cutterdeck Under Seat 11UNDER Footplate LABEL-CONTROL Panel Woods 4164679 Limited Warranty 8495 MM & Boundary Repair Parts Rev /15/2006 Woods Equipment Company