Swisher ZT18542 manual Wire Identification on ZT2350

Page 11

WIRE IDENTIFICATION ON ZT2350

WIRING HARNESS TO ENGINE PLUG CONNECTION

Gray wire goes to carburetor fuel solenoid

Green wire goes to oil pressure switch

Black wire goes to engine ignition module

Red wire goes to engine charging system

Green wire goes to hour meter

Red wire goes to terminal on solenoid with the positive battery cable.

Black wire goes to the ignition switch.

Gray wire goes to hour meter

WIRING HARNESS PLUG TO ENGINE

Gray wire goes to hour meter

Green wire goes to hour meter

Red wire goes to terminal on solenoid with the positive battery cable.

Black wire goes to the ignition switch.

8

Image 11
Contents Repair Manual Page Table of Contents Always Check Fuse First If Engine WON’T CrankBattery Ground Connection AT Engine Engine Cranks but WON’T Start Engine Stalls When PTO is EngagedIf PTO Clutch will not Engage Hour Meter not Operating Wiring DiagramStarter Solenoid Wire Identification AT Switches Ignition SwitchPTO Switch Plug Wiring Harness Plug to Engine Wire Identification on ZT18542Wiring Harness to Engine Plug Connection Wire Identification on ZT2350 Used on ZT18542 Carburetor Fuel SolenoidUsed on ZT2350 Used on the ZT2350 Battery Charging SystemsAdjustment of Steering Adjusting the Drive ControlsTracking Adjustments Replacement of the Hydro Unit Repairing or Replacing Blade Driver Clutch drive belt replacement Belt Replacement RoutingQuick Reference Replacement PartsSwisher Mower & Machine CO. INC Corporate Drive Series