Stiga PRO 18, PRO 16 manual Starting Engine, Stopping, Operating, Choke position 5b. Pro16-Pro18

Page 11

GBENGLISH

lever (only US and Canada)

In order to start the machine the following are nec- essary:

-gear lever in neutral (only Classic)

-brake pedal depressed

-driver sitting on seat

-power take-off engagement lever at lowest setting (i.e. power take-off disengaged)

Always check the operation of the safe- ty system before using the machine!

Check in the following way:

-start the engine, sit on the seat, select a gear, lift your weight off the seat - the engine must stop (applies to Classic)

-start the engine, sit on the seat, press the drive pedal so that the machine starts to move, release the drive pedal - the machine must stop (applies to President)

-start the engine, sit on the seat, press the drive pedal so that the machine starts to move, engage the cruise control, lift your weight off the seat - the machine must stop (applies to Pro16 - Pro18)

-start the engine, sit on the seat, press the drive pedal so that the machine starts to move, engage the cruise control, press the brake pedal - the machine must stop (applies to Pro16 - Pro18)

-start the engine, sit on the seat, engage the power take-off, lift your weight off the seat - the power take-off must be disengaged (all models)

Do not use the machine if the safety sys- tem does not work! Take the machine to a service agent for inspection.

STARTING ENGINE

1.Open the fuel cock (fig 11).

2.Make sure that the sparking plug cable is prop- erly in place.

3.Check to make sure the power take-off is en- gaged.

4a. Classic:

Put the gear lever in neutral.

4b. President-Pro16-Pro18:

Do not keep your foot on the drive pedal.

5a. Classic-President:

Starting cold engine - put the throttle control in the choke position. Starting warm engine - put the throttle control at full throttle (1 - 1.5 cm below the

choke position).

5b. Pro16-Pro18:

Put the throttle control at full throttle. Starting cold engine - pull the choke control out fully. Starting warm engine - do not touch the choke control.

6.Depress the brake pedal fully.

7.Turn the starter key and start the engine.

8a. Classic-President:

Once the engine has started, move the throttle con- trol gradually to full throttle if the choke has been used.

8b. Pro16-Pro18:

Once the engine has started, push the choke control in gradually if it has been used.

9.When starting from cold do not make the ma- chine work under load immediately, but let the mo- tor run for some minutes first. This will allow the oil to warm up.

STOPPING

Disengage the power take-off and apply the park- ing brake.

Allow the engine to idle for 1 - 2 minutes. Stop the engine by switching off the ignition key.

Shut off the petrol cock. This is particularly impor- tant if the machine is to be transported on a trailer, for example.

If the machine is left unattended to, re- move the lead from the spark plug. Also remove the starter key.

The engine may be very warm immedi- ately after it is shut off. Do not touch the silencer, cylinder or cooling flanges as it can cause burns and injury.

Machines with catalytic converters:

The catalytic converter gets very hot during opera- tion. The heat remains for a long time after the en- gine has been stopped.

Avoid risk of fire:

-do not park in close proximity to inflammable objects.

-do not cover the machine until the catalytic con- verter has cooled down.

OPERATING

Make sure that there is the correct quantity of oil in the engine when driving on slopes (oil level on

Image 11
Contents Stiga Park Park Classic-President Park Pro16-Pro18 Park President Park Pro16-Pro18 17.18 Park Classic-President Page Park Classic Park President Park Pro16-Pro18 Park Classic Park President-Pro16 Park Pro18 Parking Brake SymbolsService Brake GeneralStarter KEY Seat SuspensionTHROTTLE/CHOKE Control Areas of USE Park Checking the Transmission Safety SystemFilling the Fuel Tank Check the Engine OIL LevelChoke position 5b. Pro16-Pro18 Starting EngineStopping OperatingFull CleaningWhen in operation always run the engine at full throttle Changing Engine OILLubrication Changing the Transmission OIL President Pro16 Pro18AIR Bleeding President Pro16 Pro18 Replacing Engine OIL Filter Pro16 Pro18Sparking Plug BatteryAIR Filter Cooling AIR IntakeAdjusting the Drive Pedal President Pro16 Pro18 Adjusting Power Take OFF Cable not Pro18Adjusting Gear Positions Classic Adjusting Clutch ClassicEr side Tighten the pedal stop locking nut Adjusting Steering Chain Pro16 Pro18Adjusting the Brake Steering Cables Classic PresidentEC Declaration Conformity Park Classic President Pro W I N G a H E a D
Related manuals
Manual 16 pages 23.17 Kb

PRO 18, PRO 16 specifications

Stiga PRO 16 and PRO 18 are elite-level table tennis blades that exemplify exceptional craftsmanship and cutting-edge technology, targeting both competitive players and serious enthusiasts. These blades are meticulously designed for players who seek balance, power, and control, integrating various innovative features that contribute to superior performance on the table.

The Stiga PRO 16 is particularly known for its lightweight design paired with a high degree of stiffness. This blade employs a unique combination of multiple layers of wood and advanced composite materials that enhance speed while maintaining excellent control. Its 16 mm thickness strikes a harmony between power and precision, allowing players to deliver fierce shots with ease. The PRO 18, on the other hand, is slightly thicker at 18 mm, providing a more substantial feel and increased power for aggressive playstyles. This thicker build enables players to generate greater spin, making it a favored choice for those who rely on heavy topspin and fast-paced gameplay.

Both blades feature the renowned Stiga “WAVE” technology, which optimizes the wood grain orientation to maximize speed and minimize vibrations. This technology not only enhances ball feel but also improves the racket's stability during intense rallies. Additionally, they come equipped with Stiga's proprietary “Hyper Bounce” technology, ensuring that players experience consistent rebound characteristics, enabling them to execute precise strokes without compromising power.

Another defining characteristic of the Stiga PRO 16 and PRO 18 is their ergonomic handle design. Both blades feature a well-shaped handle that fits comfortably in hand, allowing for extended playing periods without fatigue. Players can personalize their experience further by choosing between different handle types, such as the Straight, Flared, or Concave designs.

Moreover, both blades are compatible with a wide range of rubber surfaces, granting players the freedom to customize their setup according to their unique preferences. The combination of these features results in blades that not only cater to advanced techniques but also enhance overall playing experience.

In conclusion, the Stiga PRO 16 and PRO 18 represent the pinnacle of table tennis technology. Their high-quality materials, advanced technologies, and thoughtful design ensure players possess the necessary tools to take their game to new heights. These blades are not just products; they are a gateway to elevated performance on the table.