Stiga PRO 18, PRO 16 manual Areas of USE Park

Page 9

GBENGLISH

2.Drive position (without symbol).

3.Start position - the electric starter motor START is activated when the key is turned to the spring-loaded start position. Once the en- gine has started, allow the key to return to

the drive position.

A spare key is enclosed in the plastic bag that also includes this "instructions for use". Keep this key in a safe place.

14.CRUISE CONTROL (Pro16 - Pro18)

A switch for activating the cruise control. The function of the cruise control allows the drive ped- al (5) to be locked in the desired position. You do not need to use the right foot.

1.Press the upper part of the switch - the lifter will be lowered to the working position.

2.Press the lower part of the switch - the lifter will be raised to the transport position.

19.EL. CUTTING HEIGHT ADJUST- MENT (Pro18)

The machine has been designed for electrical ad- justment of the cutting height (available as an ac- cessory).

A connection plug is located on the right hand side, in front of the front wheel.

The switch (orange symbol) is used to adjust the cutting height up or down in continuously variable positions.

1.Depress the drive pedal until the desired speed is achieved. Then press the rear part of the switch to activate the cruise control. The symbol will light up green.

2.Disengage the cruise control by press- ing the front part of the switch.

15.LIGHT SWITCH (not Classic)

A pull-type switch for the halogen headlamp. The headlamp works only when the engine is running - there is no load on the battery. There are two posi- tions:

20. REAR RAKE (Pro18)

The machine has been designed for the use of a rear rake, which can be raised and lowered electri- cally (available as an accessory).

Connection cables are located at the rear of the ma- chine, under the solenoid.

The switch (blue symbol) is used for raising or lowering the rear rake.

OPERATING THE MACHINE

1.Switch pulled out - headlamp "on".

2.Switch pushed in - headlamp "off".

16.POWER TAKE OFF (Pro18)

Circuit-breaker for engaging and disengaging the electromagnetic power take-off.

1.Press the lower part of the circuit-break- er - the power take-off will be engaged. The symbol will indicate green.

2.Press the upper part of the circuit-break- er - the power take-off will be disengaged.

AREAS OF USE - PARK

The machine may only be used for the following tasks using the STIGA accessories stated:

1.Mowing

Using mower deck 13-2922 (100B), 13-2913 (102M), 13-2917 (110S), 13-2915/13-2921 (121M) or flail mower 13-1977.

2.Sweeping

Using brush unit 13-1933 or collector brush unit 13-1939. Use of dust guard 13-1936 is re- commended with the first option.

17. HOUR METER (Pro18)

Indicates the number of operating hours. Works only when the engine is running.

18. ELECTRIC LIFTER (Pro18)

3.Snow clearance

Using snow blade 13-1916 or snow thrower 13-1948. Snow chains 13-1956 and wheel weights 13-1982 are recommended.

Switch (red symbol) for controlling the front-

4. Grass clipping and leaf collection

 

mounted, electric lifter.

Using towed collector 13-1978 (30") or

 

 

13-1950 (42").

 

 

 

Image 9
Contents Stiga Park Park Classic-President Park Pro16-Pro18 Park President Park Pro16-Pro18 17.18 Park Classic-President Page Park Classic Park President Park Pro16-Pro18 Park Classic Park President-Pro16 Park Pro18 Service Brake SymbolsGeneral Parking BrakeSeat Suspension THROTTLE/CHOKE ControlStarter KEY Areas of USE Park Filling the Fuel Tank Safety SystemCheck the Engine OIL Level Checking the TransmissionStopping Starting EngineOperating Choke position 5b. Pro16-Pro18When in operation always run the engine at full throttle CleaningChanging Engine OIL FullAIR Bleeding President Pro16 Pro18 Changing the Transmission OIL President Pro16 Pro18Replacing Engine OIL Filter Pro16 Pro18 LubricationAIR Filter BatteryCooling AIR Intake Sparking PlugAdjusting Gear Positions Classic Adjusting Power Take OFF Cable not Pro18Adjusting Clutch Classic Adjusting the Drive Pedal President Pro16 Pro18Adjusting the Brake Adjusting Steering Chain Pro16 Pro18Steering Cables Classic President Er side Tighten the pedal stop locking nutEC Declaration Conformity Park Classic President Pro W I N G a H E a D
Related manuals
Manual 16 pages 23.17 Kb

PRO 18, PRO 16 specifications

Stiga PRO 16 and PRO 18 are elite-level table tennis blades that exemplify exceptional craftsmanship and cutting-edge technology, targeting both competitive players and serious enthusiasts. These blades are meticulously designed for players who seek balance, power, and control, integrating various innovative features that contribute to superior performance on the table.

The Stiga PRO 16 is particularly known for its lightweight design paired with a high degree of stiffness. This blade employs a unique combination of multiple layers of wood and advanced composite materials that enhance speed while maintaining excellent control. Its 16 mm thickness strikes a harmony between power and precision, allowing players to deliver fierce shots with ease. The PRO 18, on the other hand, is slightly thicker at 18 mm, providing a more substantial feel and increased power for aggressive playstyles. This thicker build enables players to generate greater spin, making it a favored choice for those who rely on heavy topspin and fast-paced gameplay.

Both blades feature the renowned Stiga “WAVE” technology, which optimizes the wood grain orientation to maximize speed and minimize vibrations. This technology not only enhances ball feel but also improves the racket's stability during intense rallies. Additionally, they come equipped with Stiga's proprietary “Hyper Bounce” technology, ensuring that players experience consistent rebound characteristics, enabling them to execute precise strokes without compromising power.

Another defining characteristic of the Stiga PRO 16 and PRO 18 is their ergonomic handle design. Both blades feature a well-shaped handle that fits comfortably in hand, allowing for extended playing periods without fatigue. Players can personalize their experience further by choosing between different handle types, such as the Straight, Flared, or Concave designs.

Moreover, both blades are compatible with a wide range of rubber surfaces, granting players the freedom to customize their setup according to their unique preferences. The combination of these features results in blades that not only cater to advanced techniques but also enhance overall playing experience.

In conclusion, the Stiga PRO 16 and PRO 18 represent the pinnacle of table tennis technology. Their high-quality materials, advanced technologies, and thoughtful design ensure players possess the necessary tools to take their game to new heights. These blades are not just products; they are a gateway to elevated performance on the table.