Stow manual STR46SP Rules for Safe Operation, Always keep the work area well organized

STR46SP — RULES FOR SAFE OPERATION

■NEVER run engine without air filter. Severe engine damage may occur. Service air filter frequently to prevent carburetor malfunction.

■NEVER place your feet or hands inside the guard rings while starting or operating this equipment.

■AVOID wearing jewelry or loose fitting clothing that may snag on the controls or moving parts as this can cause a serious injury.

■ALWAYS keep clear of rotating or moving parts while operating the trowel.

■Moving Parts – Shut down the engine before performing service or maintenance functions. Contact with moving parts can cause serious injury.

■ALWAYS check to make sure that the operating area is clear before starting the engine.

■NEVER leave the machine unattended while running.

■ALWAYS be sure the operator is familiar with proper safety precautions and operations techniques before using trowel.

■ALWAYS keep the work area well organized.

■ALWAYS clear the work area of any debris, tools, etc. that would constitute a hazard while the trowel is in operation.

WARNING

ALWAYS check to make sure that the operating area is clear before starting the engine.

■No one other than the operator is to be in the working area when the trowel is in operation.

■NEVER allow passengers or riders on the trowel during operation.

■Always observe all applicable compulsory regulations relevant to environmental protection, especially, fuel storage, the handling of hazardous substances, and the wearing of protective clothing and equipment. Instruct the user as necessary, or, as the user, request this information and training.

■ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.

DANGER

Pay close attention to ventilation when operating the trowel in confined spaces such as tunnels, buildings or similar areas. The engine exhaust contains harmful elements. Ensure proper air flow to move engine exhaust away from the operator.

Lifting the Ride-On Trowel

CAUTION

This ride-on trowel is very heavy and awkward to move around. Use proper heavy lifting procedures and DO NOT attempt to lift the ride-on trowel by the guard rings.

The STR46SP Ride-On Power Trowel is designed to be moved and handled several ways.

The easiest way to lift the trowel is to utilize the lift loops that are welded to the frame.These lift loops are located to the left and right sides of the operator’s seat.

A strap or chain can be attached to these lift loops, allowing a forklift or crane to lift the trowel up onto and off of a slab of concrete. The strap or chain should have a minimum 2,000 pounds (1000- kg) lifting capacity and the lifting gear must be capable of lifting at least this amount.

DANGER

NEVER stand under or allow anyone else to stand under the trowel while it is being lifted.

STR46SP • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (08/01/06) — PAGE 11