An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en- gine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.
Assembly
This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.
Front handle installation
NOTE:
Label shows minimum spacing for front handle location.
1. Position front handle for comfortable operation and secure screw.
■■Engine and shaft assembly ■■Cutting attachment shield ■■Cutting attachment ■■Owner’s/operator’s manual ■■Assembly Tool (s)
Handle
Outer
Tube
Handle
Screw
Cutting Attachment Shield
1.Insert the cutting attachment shield between the outer tube and the cutting attachment mounting plate.
NOTE:
It may be necessary to loosen the retain- ing nut and clamp screw to adjust cutting attachment shield mounting plate.
2.Fit the two shims and the bracket over the outer tube and loosely install the four
3.Tighten the four
CAUTION!
Make sure the clamp screw and retaining nut are securely tightened before tightening the four
WARNING!
NEVER operate the unit without the cutting attachment shield installed and tightly secured!
|
|
| T282 |
| Bracket | Outer Tube | |
Cap Screws |
|
|
|
|
|
| Cutting |
Shim |
|
| Attachment |
|
|
| Shield |
Clamp Screw |
|
|
|
|
| Shim |
|
| Mounting | Plate | Line Cutter |
|
| ||
Drain | Retaining |
|
|
Nut |
|
| |
Screw |
|
|
|
|
|
| 7 |