ASSEMBLY
9.Place the cover sheet over the assembled frame and secure the sheet in place with plastic ties through grommets around cover frame at all locations. (See Figure 7.) DO NOT OVERTIGHTEN PLASTIC TIE.
10.Attach the hydraulic cylinder and Lift Rod (K) to the main frame and link attached to the cover frame. Use a lift rod pin, capscrew and lockwasher. To secure the lift rod to the link and a cylinder pin and cotter keys to secure the cylinder to the main frame yoke. (See Figure 8.)
Figure 7
Figure 8
11.Attach the Inner Shoe (L) to the cutter bar (See Figure 9) using the hardware shown in the parts list.
12.Install the Inner Swath Board (M) on the cutter bar (See Figure 10) using the hardware shown in the parts list.
Figure 9 | Figure 10 |
13.Install the Swath Board Bracket (N) beneath the end of the cutter bar as shown in Figure 12 using the hardware shown in the parts list. If the swath board is not installed, install it in the swath board bracket at this time.
DM | Assembly Section |