MAINTENANCE
Figure 2
To remove the disc, remove the 6 bolts (DD)(See Figure 1). To remove the hub (EE), remove the locknut (FF) and
the conical washer (GG). Pull the hub upward evenly to remove. Gearpullers may be required to remove hub from | ||
spline shaft. See Figure 3 |
| EE |
|
| |
Make sure the Conical Spring Washer (EE) is placed on the shaft before | GG | FF |
the disc retaining nut is installed. Place the washer on the shaft with |
|
|
the center up. Install the |
|
|
the nut to 200 |
|
|
and washer each time it is removed. |
|
|
IMPORTANT: Do not install hub without the conical washer in place!
Figure 3
DM | Maintenance Section |
|