Servis-Rhino DM124, DM82, DM95, DM112 manual Assembly

ASSEMBLY

6. Connect the break away tongue to the frame using a break away pin and cotter keys(E). (See Figure 4.)

Figure 4

7.Install the cover frame on the cutter bar using two M16 x 35mm bolts (F), locking plate and lockwashers at the top and three M16x35mm bolts and lockwashers (G) installed on the side. (See Figure 5.) Torque the M16 bolts to 100 FT-LBS. Use a thread-locking compound on top of 16mm bolts.(Note: Included with kit is a packet of locktight.)

8.Attach the Front Cover Frame (H) and the Rear Cover Frame

(I) to the main cover frame using 3 M10 x 100mm bolts, six M10 x 25mm bolts. Do not tighten the hardware until both frames are fully installed. (See Figure 6.) Only front frame folds, rear frame is fixed in place.

Figure 5

	Figure 6
DM 07-02	Assembly Section 3-3

© 2004 Alamo Group Inc.